This video is part of a longer animation produced by the U.S. Access Board. View the animation video in its entirety on the Access Board's website...
Search Results "Floor Surface"
-
Access Board: Toilet Rooms
-
1150A.1 General
Sites where either Test No. 1 or Test No. 3 is used and it is determined that an accessible route to the common (lobby) entrance is not required, at least 20 percent of the ground floor...
-
M301.2.2 Size
The transfer surface shall be 30 inches (760 mm) wide minimum and 15 inches (381mm) deep minimum. Advisory M301.2.2 Size....
-
11B-233.3.1.2.6 Public housing facility site impracticality
The site impracticality tests in this section may be used to determine the number of required residential dwelling units with adaptable features in buildings without an elevator,...
-
11B-233.3.1.2.6 Public housing facility site impracticality
The site impracticality tests in this section may be used to determine the number of required residential dwelling units with adaptable features in buildings without an elevator,...
-
7(2)(b)(v)
The top of the fixture rim is a maximum height of 2'10" above the finished floor. If kneespace is provided below the vanity, the bottom of the apron is at least 2'3" above the floor....
-
Magnuson Group UMEA Waste Receptacles
Constructed of painted steel and suitable for both indoors and outdoors, UMEA models can be 1, 2 or 3-compartments wide – each with selectable top inserts and corresponding front...
-
Landscape Forms Inc. Select Modular Steel Recycling Units
Extremely versatile, Select is a modular system of steel recycling units created by industrial designer Brian Kane. Engineered and built for outdoor use the well-proportioned...
-
Surface
Surface The surface of the transfer platform and steps must not be sharp and must have rounded edges to prevent injuries....
-
Figure 1007.3.2 Golf Club Reach Range Area – Drawing from the U.S. Access Board
-
11B-407.4.8.1.3 Floor arrival
As the car passes a floor and when a car stops at a floor served by the elevator, the corresponding character shall illuminate. Exception: Reserved....
-
11B-407.4.8.1.3 Floor arrival
As the car passes a floor and when a car stops at a floor served by the elevator, the corresponding character shall illuminate. Exception: Reserved....
-
M301.2.4 Unobstructed Transfer
Each transfer surface shall provide two unobstructed sides for patient transfer. EXCEPTIONS: 1....
-
Rough Form and Foundation Inspection
ensure correct accessible slopes (5% running slope and 2.08% cross slope). 11B-403 Verify forms for sidewalks, ramps, landings, curb ramps and clear floor...
-
Rough Form and Foundation Inspection
ensure correct accessible slopes (5% running slope and 2.08% cross slope). 11B-403 Verify forms for sidewalks, ramps, landings, curb ramps and clear floor...
-
M301.2.3 Transfer Sides
The transfer surface shall be located to provide options to transfer from a mobility device onto one short side (depth) and one long side (width) of the surface....
-
Surface
Surface Since people using transfer walls are in bathing suits, their skin may be in contact with the wall....
-
Sloped Surfaces
Measuring the slope of a ramp, parking space, pedestrian route, or other ground or floor surface is important to identify whether the surface is accessible....
-
Accessible Parking Spaces [§502]
Accessible Parking Spaces [§502] Requirements for accessible parking spaces address the size and marking of regular and van spaces and access aisles, surfaces, vertical clearance at van...
-
7(2)(b)(iv)
The other (non-grab bar) side of the toilet fixture is a minimum of 1'3" from the finished surface of adjoining walls, vanities or from the edge of a lavatory. (See Figure 7(a).)...
-
Doors
11B-404.2.7 Closing speed 11B-404.2.8.1 5lbs opening force 11B-404.2.9 10” smooth surface...
-
Doors
11B-404.2.7 Closing speed 11B-404.2.8.1 5lbs opening force 11B-404.2.9 10” smooth surface...
-
M301.3.1 Transfer Supports
Transfer surfaces required by M301.2 shall provide transfer supports and shall comply with M305.2....
