Curved ramps are not prohibited by Chapter 11B; however, requirements for maximum slope and cross-slope cannot be exceeded. ◼...
Search Results "Expected Maximum Flight Duration"
-
11B-405.3 Cross slope
-
1009.2.1 Pool Lift Location
Where multiple pool lift locations are provided, no more than one pool lift shall be required to be located in an area where the water level is 48 inches (1220 mm) maximum....
-
407.4.8.2.1 Signal Type
EXCEPTION: For elevators other than destination-oriented elevators that have a rated speed of 200 feet per minute (1 m/s) or less, a non-verbal audible signal with a frequency of 1500 Hz maximum...
-
23. How should an employer handle requests for modified or part-time schedules for an employee covered by both the ADA and the Family and Medical Leave Act (FMLA)?
When such leave is foreseeable based on planned medical treatment, an employer may require the employee to temporarily transfer (for the duration of the leave) to an available alternative...
-
Q. COMPLIANCE
The Court shall retain continuing and exclusive jurisdiction for the duration of the Decree to enforce the terms of the Decree....
-
C. Corporate ADA Contact Person, ADA Liaison, and ADA Grievance Procedure
Each ADA Liaison shall also be responsible for documenting disability-related requests on board ships during the duration of the cruise and will report the nature and outcome of all ADA-related...
-
IMPLEMENTATION AND ENFORCEMENT
The duration of this Agreement will be two years from the effective date....
-
Q. COMPLIANCE
The Court shall retain continuing and exclusive jurisdiction for the duration of the Decree to enforce the terms of the Decree....
-
Standards
deviation of 3mm in 3m, Class B has a maximum deviation of 6mm in 3m, and a Class C has a maximum deviation of 6 mm in 600 mm....
-
Bus Stop Pads
The proposed rule specified that these dimensions were required to "the maximum extent allowed by legal or site constraints" (1002.2.2)....
-
Shower Spray Unit
Comments also noted that delivered water should be "temperature limited" to the specified maximum (120 degrees) for consistency with American Society of Safety Engineers (ASSE) standards...
-
404.2.7 Door and Gate Hardware
Operable parts of such hardware shall be 34 inches (865 mm) minimum and 48 inches (1220 mm) maximum above the finish floor or ground....
-
Height and Clearances [4.19.2]
Only a portion of the usable clear floor space can "count" as toe space, which is why a maximum depth and minimum height are specified for the front of the underlap of the required clear...
-
2.3.4 Analysis of Door Use Difficulty
The mean, median and range of WhMD user age, occupied width, occupied length and maximum power grip were also reported as we thought that these variables might help explain the door use...
-
4.26.3 STRUCTURAL STRENGTH
structural strength of grab bars, tub and shower seats, fasteners, and mounting devices shall meet the following specification: (1) Bending stress in a grab bar or seat induced by the maximum...
-
404.2.7 Door and Gate Hardware
Operable parts of such hardware shall be 34 inches (865 mm) minimum and 48 inches (1220 mm) maximum above the finish floor or ground....
-
404.2.7 Door and Gate Hardware
Operable parts of such hardware shall be 34 inches (865 mm) minimum and 48 inches (1220 mm) maximum above the finish floor or ground....
- BTX Intelligent Fashion Motorized Drapery Systems
-
Accessible Route to Dumpster and Enclosure
accessible route on the design drawings (both the prototype drawings and especially the construction documents) to clearly communicate to the Contractor the higher level of responsibility expected...
-
M301.2.1 Adjustability
A low transfer position at a height of 17 inches (430 mm) minimum and 19 inches (485 mm) maximum; B. A high transfer position at 25 inches (635 mm); and C....
-
§382.9(e)(1)
(1) If you submit a waiver request on or before September 10, 2008, the Department will, to the maximum extent feasible, respond to the request before May 13, 2009....
-
§382.133(b)
during air transportation to, from or within the United States, an electronic assistive device specified in paragraph (d) of this section on all aircraft originally designed to have a maximum...
-
M302.2.1 Adjustability
A low transfer position at a height of 17 inches (430 mm) minimum and 19 inches (485 mm) maximum; B. A high transfer position at 25 inches (635 mm); and C....
-
404.2.11 Vision Lights
adjacent to doors or gates, containing one or more glazing panels that permit viewing through the panels shall have the bottom of at least one glazed panel located 43 inches (1090 mm) maximum...