Space between two doors in a series shall be 48 inches (1219 mm) minimum plus the width of a door swinging into the space....
Search Results "Curb Ramp Width"
-
1010.1.7 Door arrangement
-
11B-812.8.7 Location
Signs shall be permanently posted either immediately adjacent to the vehicle space or within the projected vehicle space width at the head end of the vehicle space....
-
11B-812.8.7 Location
Signs shall be permanently posted either immediately adjacent to the vehicle space or within the projected vehicle space width at the head end of the vehicle space....
-
1010.1.7 Door arrangement
Space between two doors in a series shall be 48 inches (1219 mm) minimum plus the width of a door swinging into the space....
-
Clear Floor Space: ADA Standard Section 808.3
alterations, wheelchair spaces are not required to be located within the defined area of raised jury boxes or witness stands and shall be permitted to be located outside these spaces where ramp...
-
11B-705.1.2.6 Reflecting pools
When detectable warnings are provided at reflecting pools, it shall be 24 inches (610 mm) minimum and 36 inches (914 mm) maximum in width....
-
§382.133(e)(2)
(2) The maximum weight and dimensions (length, width, height) of the device to be used by an individual that can be accommodated in the aircraft cabin consistent with FAA safety requirements...
-
Technical Requirements
Technical Requirements—Specific numbers, conditions, and measurements that are required to be achieved (percent that must comply, dimensions, reach ranges, grades, trail width, etc.)....
-
11B-505.2.1 Orientation
The orientation of at least one handrail shall be in the direction of the stair run, perpendicular to the direction of the stair nosing, and shall not reduce the minimum required width of...
-
11B-705.1.2.6 Reflecting pools
When detectable warnings are provided at reflecting pools, it shall be 24 inches (610 mm) minimum and 36 inches (914 mm) maximum in width....
-
11B-505.2.1 Orientation
The orientation of at least one handrail shall be in the direction of the stair run, perpendicular to the direction of the stair nosing, and shall not reduce the minimum required width of...
-
Accessibility - Flatness and Lippage
Setting Bed Materials Joint Widths Construction Tolerances Sand setting beds for concrete pavers and paving slabs Joint width between adjacent units (See Figure...
-
206.2.1 Site Arrival Points
ETA Editor’s Note: Requirements for curb ramps, sidewalks and other elements in the public right of way may be covered by other Federal, State or local standards and regulations....
-
215 Fire Alarm Systems
Curb ramps no longer required to have detectable warnings except in transportation facilities (see 218 Transportation Facilities. Page 76)...
-
What barriers will it be "readily achievable" to remove?
The Department's regulation contains a list of 21 examples of modifications that may be readily achievable: 1) Installing ramps; 2) Making curb cuts in sidewalks and entrances;...
-
II-3.6100 General
ILLUSTRATION 1: A municipal zoning ordinance requires a set-back of 12 feet from the curb in the central business district....
-
1133A.2.1, Item 3
All other kitchen designs shall provide a minimum clear width of at least 48 inches (1219 mm). (See Figure 11A-10A)....
-
Parking Spaces for Vehicles Other Than RVs [F244.2.3.2.2]
Parking spaces for vehicles other than RVs within camping units with mobility features must comply with the following technical requirements for width, surface, and slope....
-
T702.3 Character Proportions
Characters shall use fonts where the width of the uppercase letter “O” is 55 percent minimum and 110 percent maximum of the height of the uppercase letter “I”....
-
Egress Stairs
The requirement for a minimum 48 inch width between handrails is specific to stairs adjacent to areas of rescue assistance and does not apply generally to stairs covered by 4.9....
-
1133A.2.1, Item 3
All other kitchen designs shall provide a minimum clear width of at least 48 inches (1219 mm). (See Figure 11A-10A)....
-
11B-813.2.1.1 Size
Adult changing tables shall have a changing surface of 70 inches (1778 mm) minimum length and 30 inches (762 mm) minimum width....
-
Summary
Summary The following report provides a brief analysis of four anthropometric dimensions which were considered relevant to the width and depth dimensions of a seating surface for wheeled...
-
Clearance in Base (M301.4.1 and M302.4.1)
Where the width of the examination surface is less than 36 inches, the clearance depth would be required to extend the full width of the equipment....