In assembly areas with ramped aisles or stepped aisles, one accessible means of egress is permitted where the common path of egress travel is accessible and meets the requirements in Section...
Search Results "Ramp Width"
Filters
Commonly Searched Documents
-
1009.1 Accessible means of egress required
-
11B-108 Maintenance of accessible features
It is not sufficient to provide features such as accessible routes, parking, elevators, ramps or signage if those features are not maintained in a manner that enables individuals with disabilities...
-
11B-810.5.3 Platform and vehicle floor coordination
operationally or structurally feasible to meet the horizontal gap or vertical difference requirements of part 1192 or 49 CFR part 38, mini-high platforms, car-borne or platform-mounted lifts, ramps...
-
F206.7.9 Team or Player Seating
While the use of platform lifts is allowed, ramps are recommended to provide access to player seating areas serving an area of sport activity....
-
§382.95(b)
(b) As a carrier, you must, except as otherwise provided in this subpart, provide boarding and deplaning assistance through the use of lifts or ramps at any U.S. commercial service airport...
-
206.7.9 Team or Player Seating
While the use of platform lifts is allowed, ramps are recommended to provide access to player seating areas serving an area of sport activity....
-
1.1.3
1.1.3 A maximum overall design running slope for exterior accessible surfaces (other than ramps), such as sidewalks, of 4% (approximately 1:25) is recommended....
-
Accessible Routes
The accessible route must comply with ADAAG provisions for the location, width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level...
-
Accessible Routes
Accessible route requirements in ADAAG address width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level, doors, egress, and areas...
-
5.2.1.4 Transfer Surface Size for Imaging Equipment
The width of the patient scanning/imaging table (side to side) at the designated transfer location should be 28 inches minimum or the maximum extent technically feasible, but in all cases...
-
5.2.2 Transfer Surface Size Recommendations for M302
The transfer surface size has two components: width and depth. (See Figure 5.2.1.1) NPRM Proposed Provision: M302.2.2 Size....
-
D. Entering the Emergency Shelter
An accessible entrance must provide at least one accessible door with maneuvering space, accessible hardware, and enough clear width to allow people who use crutches, a cane, walker, scooter...
-
Character Proportion [4.30.2]
Consider uniform stroke widths which can make signs easier to read....
-
Doors and Gates in Series [§404.2.6]
Doors and Gates in Series [§404.2.6] At hinged or pivoted doors or gates in series, a separation is required that is at least 48” plus the width of doors or gates swinging into the space...
-
Doors and Gates Operated Only By Security Personnel [§404.1, Ex]
If automated, such doors or gates are required to comply only with provisions for clear width and thresholds, as well as applicable provisions of the referenced ANSI/BHMA Standards....
-
§ 38.23(b)(7) Platform gaps
Any openings between the platform surface and the raised barriers shall not exceed 5/8 inch in width....
-
F. Swimming Pool Entrance and Deck
(4) The swimming pool deck ramp, which has an intermediate ramp landing area that is 37 ½ inches long, rather than the required 60 inches, will be supplemented by a platform lift at...
-
Power Wheelchairs
They often cannot be folded or disassembled for transport, so a ramp or lift-equipped van is required....
-
3.3.2 Experienced Clinicians
The Committee is considering two main options: minimum widths of 28” or 30”. “Tables” are equipment used by patients in supine, prone, or side-lying positions....
-
Rubbermaid 7818-88 Horizontal Baby Changing Station
cm Height: 4.0 in 10.2 cm Carton Length: 33.9 in 86.2 cm Carton Width...
-
Inpro Corporation JointMaster® 316 Series Single Sightline for Carpet Floor Expansion Joint Covers
Features & Benefits System reduces joint widths of up to 4" (100mm) down to a narrow sightline of only 1" (25mm) Specially designed for continuous flooring types such...
-
Accessible routes
Accessible routes that coincide with, or are located in the same area, as general circulation paths and elements such as ramps, elevators, and fare vending and collection must be placed...
-
11B-809.7.2 Changes in level
Ramps complying with Section 11B-405, elevators complying with Section 11B-407 or platform lifts complying with Section 11B-410 shall be provided where changes in level exceed 1/2 inch (...
-
A. Accessible Voting Program
condition on Election Day those features of facilities and equipment (including, but not limited to, permanent equipment such as lifts and elevators, and temporary equipment such as portable ramps...
