These technical criteria are available at http://www.access-board.gov/ada-aba/final.cfm#a505 and address continuity, height, clearance, gripping surface, cross section, surfaces, fittings...
Search Results "Adjustable Height Counter"
Commonly Searched Documents
-
Additional Technical Criteria Considered for Handrails on Ramps
-
11B-505.10.3 Bottom extension at stairs
The horizontal extension of a handrail shall be 12 inches (305 mm) long minimum and a height equal to that of the sloping portion of the handrail as measured above the stair nosings....
-
11B-703.8.5 Character width
TABLE 11B-703.8.5 PIXEL COUNT FOR LOW RESOLUTION VMS CHARACTER HEIGHT CHARACTER WIDTH RANGE STROKE WIDTH RANGE CHARACTER SPACING RANGE 7 5-6...
-
11B-216.3 Directional and informational signs
It should be noted that exterior signs are likely to be viewed at a greater distance than interior signs, which would affect the prescribed height of visual characters.  ...
-
11B-308.3.2 Obstructed high reach
Where a clear floor or ground space allows a parallel approach to an element and the high side reach is over an obstruction, the height of the obstruction shall be 34 inches (864 mm) maximum...
-
11B-703.8.5 Character width
TABLE 11B-703.8.5 PIXEL COUNT FOR LOW RESOLUTION VMS CHARACTER HEIGHT CHARACTER WIDTH RANGE STROKE WIDTH RANGE CHARACTER SPACING RANGE...
-
11B-308.3.2 Obstructed high reach
Where a clear floor or ground space allows a parallel approach to an element and the high side reach is over an obstruction, the height of the obstruction shall be 34 inches (864 mm) maximum...
-
11B-705.2 Detectable directional texture
Detectable directional texture at transit boarding platforms shall comply with Figure 11B-705.2 and shall be 0.1 inch (2.5 mm) in height that tapers off to 0.04 inch (1.0 mm), with bars...
-
11B-216.3 Directional and informational signs
It should be noted that exterior signs are likely to be viewed at a greater distance than interior signs, which would affect the prescribed height of visual characters....
-
11B-703.7.2.6 Toilet and bathing facilities geometric symbols
When toilet and bathing facilities have doorway openings instead of doors, such as at airports or stadiums, the geometric identification symbol should be located at the proper height adjacent...
- DORMA BTS75V SERIES DOOR CLOSER
- BEA Inc. LZR-Microscan Swinging Door Sensor
- TownSteel TDC 90 ALUMINUM Grade 1 Door Closer
- TownSteel TDC 70 ALUMINUM Grade 1 Door Closer
- TownSteel TDC 40, CAST IRON Grade 1 Door Closer
- Yale 5100 Series Light Duty Door Closer
-
ICC/IBC: ADA Standard Section 105.2.4
Section 105.2.4 of the ADA Standards cover references to the International Code Council (ICC) and the International Building Code (IBC).
-
Common Problems with Toilet Rooms
Ø     The sink counter is too high, or there is insufficient knee clearance.  Ø     The sink has exposed hot water and drain pipes, which can cause serious burns....
-
11B-805.7 Built-in cabinets and work surfaces
Built-in cabinets, counters and work surfaces shall be accessible, including: patient wardrobes, nurse’s stations, administrative centers, reception desks, medicine preparation areas, laboratory...
-
Plan 4A: 13-Foot Wide Accessible Guest Room
The following accessible features are provided in the bathroom: • Comparable vanity counter top space (section 806); • Standard roll-in type shower with folding seat (section 608.2.2...
-
Overview of Proposed Guidelines
and alternative requirements for audible sign systems and other technologies; Street furniture for pedestrian use, including drinking fountains, public toilet facilities, tables, counters...
-
11B-205.1 General
Where two or more outlets are provided in a kitchen above a length of counter top that is uninterrupted by a sink or appliance, one outlet shall not be required to comply with 309....
- Cybex Total Access Row/Rear Delt Exercise Machine
- Cal-Royal CR801 Series Hydraulic Door Closers