The clear width for aisles shall be 36 inches (914 mm) minimum if serving elements on only one side, and 44 inches (1118 mm) minimum if serving elements on both sides....
Search Results "Transfer Side"
Commonly Searched Documents
- 
    
  
  11B-403.5.1 Clear width
  
 - 
    
  
  810.6.3 Station Names
  
Signs shall be clearly visible and within the sight lines of standing and sitting passengers from within the vehicle on both sides when not obstructed by another vehicle....
 - 
    
  
  11B-402.2 Components
  
Accessible routes shall consist of one or more of the following components: walking surfaces with a running slope not steeper than 1:20, doorways, ramps, curb ramps excluding the flared sides...
 - 
    
  
  Grab Bars
  
Grab bars are required on one side wall and the rear wall....
 - 
    
  
  402.2 Components
  
Accessible routes shall consist of one or more of the following components: walking surfaces with a running slope not steeper than 1:20, doorways, ramps, curb ramps excluding the flared sides...
 - 
    
  
  Roll-in Access [1014.2.2]
  
provide roll-in access into a camp shelter, a level or sloped entry route that complies with the technical requirements for an ORAR or trail, as applicable, must be provided along the open side...
 - 
    
  
  R309.3 Perpendicular or Angled Parking Spaces
  
Perpendicular and angled parking spaces permit the deployment of a van side-lift or ramp....
 - 
    
  
  402.2 Components
  
Accessible routes shall consist of one or more of the following components: walking surfaces with a running slope not steeper than 1:20, doorways, ramps, curb ramps excluding the flared sides...
 - 
    
  
  608.3.2 Standard Roll-In Type Shower Compartments
  
Where a seat is provided in standard roll-in type shower compartments, grab bars shall be provided on the back wall and the side wall opposite the seat....
 - 
    
  
  5.3.2.1 Size
  
The clear floor or ground space shall be 60 inches (1525 mm) wide minimum measured parallel with the back of the pit toilet, and 56 inches (1420 mm) deep minimum measured parallel to the sides...
 - 
    
  
  4.13.9* Door Hardware
  
When sliding doors are fully open, operating hardware shall be exposed and usable from both sides....
 - 
    
  
  5.3.2.1 Size
  
The clear floor or ground space shall be 60 inches (1525 mm) wide minimum measured parallel with the back of the pit toilet, and 56 inches (1420 mm) deep minimum measured parallel to the sides...
 - 
    
  
  Curb Ramps at Intersections
  
Curb ramps at marked crossings must be wholly contained within the crosswalk, excluding side flares....
 - 
    
  
  § 38.39(b)
  
width-to-height ratio between 3:5 and 1:1 and a stroke width-to-height ratio between 1:5 and 1:10, with a minimum character height (using an upper case “X”) of 1 inch for signs on the boarding side...
 - 
    
  
  11B-402.2 Components
  
Accessible routes shall consist of one or more of the following components: walking surfaces with a running slope not steeper than 1:20, doorways, ramps, curb ramps excluding the flared sides...
 - 
    
  
  11B-206.2.19 Pedestrian street crossings
  
The curb ramp (excluding any flared sides) or blended transition shall be contained wholly within the width of the pedestrian street crossing served....
 - 
    
  
  11B-802.1.2 Width
  
It should be noted that although side access to the wheelchair space is allowed, companion seating in compliance with Section 11B-802.3 must also be provided adjacent to each wheelchair...
 - 
    
  
  11B-810.6.3 Station names
  
Signs shall be clearly visible and within the sight lines of standing and sitting passengers from within the vehicle on both sides when not obstructed by another vehicle....
 - Allegion LCN 1460 Series Surface Mounted Door Control
 - 
    
  
  Door and Gate Hardware: ADA Standard Section 404.2.7
  
Section 404.2.7 covers the current ADA Standards for door and gate hardware.
 - 
    
  
  F105.2.2 ASME
  
that at least two flat steps be provided at the entrance and exit of every escalator and that steps on escalators be demarcated by yellow lines 2 inches wide maximum along the back and sides...
 - 
    
  
  11B-203 General exceptions
  
For imaging equipment, the aisle width requirements shall apply to only those sides of the equipment where staff typically work to provide medical care to patients, including assisted transfer...
 - 
    
  
  How should we describe facilities that only meet some of the accessibility guidelines?
  
While the side entrance was being renovated to make it accessible, a doorbell with the International Symbol of Accessibility (the wheelchair symbol) was provided on the kiosk in front of...