Provide integrated wheelchair seating areas for two wheelchairs and two companion seats at the following locations: a. "21st Century" Theater; b....
Search Results "Fixed Assembly Seating"
Filters
Commonly Searched Documents
-
c. i.
-
§ 37.167(j)(1)
(1) When an individual with a disability enters a vehicle, and because of a disability, the individual needs to sit in a seat or occupy a wheelchair securement location, the entity shall...
-
D.
entities' own policies and practices, and not regulatory requirements contained in 49 CFR parts 27, 37, 38, and 39, such as complementary paratransit service going beyond 3/4 mile of the fixed...
-
Invisible Wounds: Emerging Promising Practices for Meeting Planners
Advertise the availability of these seats and make sure event staff know about them....
-
Re: Single User Restroom Accessibility
I think Assembly Bill only relates to signage, not the accessibility, therefore, I would observe the plumbing code first and provide accessible restrooms then provide unisex signage....
-
PEMKO 2" to 48" Aluminum Plates No. 18/1
Cover Plate Assemblies are available for use whenever an unusual floor condition occurs....
-
T704 Announcement Systems
Automated stop announcement systems must provide audible and visible notification of upcoming stops on fixed routes....
-
11B-803.1 General
Section 903.5 requires dressing room bench seats to be installed so that they are at the same height as a typical wheelchair seat, 17 inches (430 mm) to 19 inches (485 mm)....
-
Lines of Sight at Dining Areas in Sports Venues
Designers called attention to dining areas integrated into the seating bowl of sports venues that are tiered in order to provide adequate lines of sight....
-
§ 36.302(f)(5)(iii)(A) Series-of-events tickets sell-out when no ownership rights are attached
When series-of-events tickets are sold out and a public accommodation releases and sells accessible seating to individuals without disabilities for a series of events, the public accommodation...
-
§ 35.138(e)(3)(i)
When series-of-events tickets are sold out and a public entity releases and sells accessible seating to individuals without disabilities for a series of events, the public entity shall establish...
-
11B-803.1 General
Section 903.5 requires dressing room bench seats to be installed so that they are at the same height as a typical wheelchair seat, 17 inches (430 mm) to 19 inches (485 mm)....
-
11B-803.1 General
Section 11B-903.5 requires dressing room bench seats to be installed so that they are at the same height as a typical wheelchair seat, 17 inches (430 mm) to 19 inches (485 mm)....
-
III-4.4700 Transportation barriers
the acquisition of new vehicles are found in the Department of Transportation regulation and vary depending on both the capacity of the vehicle and its intended use, as follows: 1) Fixed...
-
106 Definitions
Definitions that have been revised include: "assembly area," "common use," "mezzanine," "residential dwelling unit," "transient lodging," "vehicular way," and "walk."...
-
Carry Information and Useful Documentation
Carry Information and Useful Documentation Bringing photocopies of instructions about the assembly and disassembly of wheelchairs and other assistive devices when you access air transportation...
-
213.3.1 Toilet Compartments
Full-height partitions and door assemblies can comprise toilet compartments where the minimum required spaces are provided within the compartment....
-
26.1 Q. Is a parallel approach required at the shower, as shown in Figure 7(d) of the Guidelines?
For a 36 x 36 shower, as shown in Figure 7(d), a person in a wheelchair would typically add a wall hung seat....
-
Kawneer North America 1010 Sliding Mall Front
Key Features Include: Available with both fixed and operable panels Accept glazing infills from less than 1/4" to 1" (6.4 to 25.4) 1-3/4" (44.5mm) sightline 1-3/4" (44.5mm)...
-
Gangway Slope and Rise Exceptions
This would include a ramp connecting a fixed pier or a float with fixed switchback ramps....
-
Alterations
remodeling, renovating, rehabilitating, reconstructing, changing or rearranging structural parts or elements, changing or rearranging plan configuration of walls and full-height or other fixed...
-
STEP 2: TELL YOUR ARCHITECT AND BUILDING CONTRACTOR THAT YOU EXPECT YOUR NEW FACILITY TO COMPLY WITH THE ADA.
You should also include terms in design and building contracts that require your architect and building contractor to fix and pay the costs of fixing all ADA mistakes discovered during and...
-
11B-1008.4.2 Clear floor or ground space
When designing play components with manipulative or interactive features, consider appropriate reach ranges for children seated in wheelchairs....
-
1002 Amusement Rides
Provisions for amusement rides require either a wheelchair space on the ride, a ride seat designed for transfer, or a device designed for transfer to the ride....
