Where play components require transfer to entry points or seats, the entry points or seats shall be 11 inches (279 mm) minimum and 24 inches (610 mm) maximum from the clear floor or ground...
Search Results "Transfer Technique"
Filters
Commonly Searched Documents
-
11B-1008.4.4 Entry points and seats
-
5.3.3.1 Transfer Sides Recommendation for Exam Chairs with Fixed Footrests
right transfer....
-
Grab Bars: ADA Standard Section 1009.4.5
At least one grab bar complying with 609 shall be provided on the transfer wall. Grab bars shall be perpendicular to the pool wall and shall extend the full depth of the transfer wall....
-
502.1 General
Car and van parking spaces shall comply with 502. Where parking spaces are marked with lines, width measurements of parking spaces and access aisles shall be made from the centerline...
-
11B-502.1 General
Car and van parking spaces shall comply with Section 11B-502. Where parking spaces are marked with lines, width measurements of parking spaces and access aisles shall be made from...
-
How to Measure Access Aisles
In the final rule, the Board has clarified how parking spaces and access aisles are to be measured. Where parking spaces are marked with lines, the width of parking spaces and...
-
Q6.) How important is the method of measurement in considering the tolerances allowable in finished construction?
A6.) Methods of measurement are critical in determining both compliance and allowable tolerances. The industry’s standards are usually very clear about how to make their...
-
502.1 General
Car and van parking spaces shall comply with 502. Where parking spaces are marked with lines, width measurements of parking spaces and access aisles shall be made from the centerline...
-
B. Measuring Clear Passage at Doors
Verifying the clear passage width at standard hinged doors requires an understanding of exactly where to measure. The photo below shows that you measure horizontally from the face of...
-
Door Clear Width
Door Clear Width Open the door 90 degrees, measure from the face of the door to the edge of the door stop.
-
502.1 General
502.1 General. Car and van parking spaces shall comply with 502. Where parking spaces are marked with lines, width measurements of parking spaces and access aisles shall be made from...
-
502.1 General
Car and van parking spaces shall comply with 502. Where parking spaces are marked with lines, width measurements of parking spaces and access aisles shall be made from the centerline...
-
California Toilet Paper Dispenser Template
California Toilet Paper Dispenser Template Click here to view/download the pdf "California Toilet Paper Dispenser Template" (468 KB) * * * * * * *
-
1.1.11 Ramp running slope
1.1.11 Ramp running slope. Measure for overall running slope of ramps by determining elevations at the top and bottom of the ramp at the midpoint of the width of each ramp run and...
-
11B-502.1 General
Car and van parking spaces shall comply with Section 11B-502. Where parking spaces are marked with lines, width measurements of parking spaces and access aisles shall be made from...
-
11B-502.1 General
Car and van parking spaces shall comply with Section 11B-502. Where parking spaces are marked with lines, width measurements of parking spaces and access aisles shall be made from...
-
11B-1009.4.5 Grab bars
At least one grab bar complying with Section 11B-609 shall be provided on the transfer wall....
-
5.3.3 Transfer Sides for Equipment Used by Patients in Seated Position
5.3.3 Transfer Sides for Equipment Used by Patients in Seated Position....
-
(2) Transfer Surface Location for Diagnostic Equipment Used in the Seated Position
Transfer onto these types of diagnostic equipment must be made from either long side, similar to the side transfer surface described above....
-
Figure 1009.5.1 Size of Transfer Platform – Drawing from the U.S. Access Board
-
(3) Transfers of Privately Held Equity Interests
(3) Transfers of Privately Held Equity Interests: A transfer of interest in a Brand Hotel in which, after conveyance of the interest, a 25% or more cumulative interest in the Brand Hotel...
-
1002.5.2 Transfer Height
The height of amusement ride seats designed for transfer shall be 14 inches (355 mm) minimum and 24 inches (610 mm) maximum measured from the surface of the load and unload area....
-
1002.5.2 Transfer Height
The height of amusement ride seats designed for transfer shall be 14 inches (355 mm) minimum and 24 inches (610 mm) maximum measured from the surface of the load and unload area....
-
Studies of Wheeled Mobility Devices and Transferring Abilities
Studies of Wheeled Mobility Devices and Transferring Abilities Accessible medical equipment needs to facilitate safe transfers that accommodate the largest possible portion of people...
