[ADA Standards § 4.10.12 (3)] Yes No...
Search Results "Referenced Standard"
-
e-iv
-
d-vi
[ADA Standards § 4.8.4] Yes No...
-
M6
[ADA Standards §§ 4.22.3; 4.2.3] Yes No...
-
K6
[ADA Standards § 5.5] Yes No...
-
Question 9
Is there a need for separate standards for bariatric medical equipment and furniture in the Department's equipment and furniture regulation?...
-
Raised Crossings
Consult local Standards for application requirements, including slope for vehicle traffic, height, and markings....
-
11B-805 Medical care and long-term care facilities
ETA Editor's Note The numbering of subsections within Section 11B-805 is not aligned between CBC and 2010 ADA Standards....
-
E202.6.1 Required Documentation (Section-by-Section Analysis)
Documentation (Section-by-Section Analysis) This section proposes to require that agencies document in writing the basis for determining that ICT fully conforming to applicable 508 Standards...
-
Sections 4.8.5 and 4.9.4
• Sections 4.8.5 and 4.9.4 of the 1991 Standards require handrail gripping surfaces to be continuous, and to be uninterrupted by newel posts, other construction elements, or obstructions...
-
QUALIFIED INTERPRETERS
An individual does not have to be certified in order to meet this standard....
-
101.1 General
These standards are intended to be consistent to those contained in the 2010 Standards for Accessible Design, and are generally the same except as noted in italics....
-
Q5: Should a school district revise its policies and procedures regarding the determination of coverage and provision of services under Section 504 and Title II?
A: Yes, if those policies and procedures do not implement the Amendments Act's new legal standards....
-
Introduction
recommendations on best practices for physical accessibility and customer service that go above and beyond the minimum requirements contained within the 2010 Americans with Disabilities Act (ADA) Standards...
-
A.2.ii. - Should EIT be compatible with assistive technology?
In some cases, the standards require that the acquired EIT be readily usable without the need for assistive devices....
-
Are self-evaluations and transition plans required to be updated?
Although there is no requirement to update them, updating is the best means to ensure compliance with current regulations and design standards. A lot has changed in 27 years....
-
A. Accessibility Laws
. §§ 12101, et seq. and all of its implementing regulations and design standards; the Rehabilitation Act of 1973, 29 U.S.C. §§ 790, et seq. and all of its implementing regulations and design...
-
Minimum Clear Headroom
The commenters stated that standard doors provide a height range from 75 to 79 inches, and that an 80-inch specification would considerably increase the cost of each door installed....
-
The National Highway Traffic Safety Administration’s (NHTSA) motor vehicle safety regulations require that a wheelchair lift be tested to withstand a 600-pound load. If the manufacturer states that the design load is 800 pounds, can the transportation operator limit actual use to 600 pounds for safety reasons?
The NHTSA safety standards and the DOT ADA regulations were designed to complement each other....
-
407.7 Color (Section-by-Section Analysis)
The proposed section is the same as existing 508 Standards § 1195.25(g), and is consistent with 255 Guidelines § 1193.41(c)....
-
4.10.12(2)
All control buttons shall be designated by Braille and by raised standard alphabet characters for letters, arabic [sic] characters for numerals, or standard symbols as shown in Fig. 23(a...
-
Mirrors [4.19.6]
The mounting height of the bottom of mirrors at accessible lavatories (40 inches maximum above the floor) is based on the standard eye level range of adults seated in wheelchairs (43 to...
-
205 Operable Parts
1991 Standards for Accessible Design 2010 Standards for Accessible Design What’s New/Different 4.1.3(13) Controls...
-
223 Medical Care and Long-Term Care Facilities
1991 Standards for Accessible Design 2010 Standards for Accessible Design What’s New/Different 6.1 General....
-
4.10.12(2)
All control buttons shall be designated by raised standard alphabet characters for letters, arabic characters for numerals, or standard symbols as shown in Fig. 23(a), and as required in...