Door: Formed door with 1-1/4” trim, mounted in a 5/8” door stop attached by a continuous hinge. ...
Search Results "Door Stop"
Filters
Commonly Searched Documents
-
Activar JL Industries 1900 Series Dual AED & Emergency Oxygen Recessed or Surface-Mounted Cabinet
-
BHMA
ANSI/BHMA A156.10-1999 American National Standard for Power Operated Pedestrian Doors (see 404.3)....
-
EXIT
Exit components include exterior exit doors at the level of exit discharge, interior exit stairways and ramps, exit passageways, exterior exit stairways and ramps and horizontal exits....
-
H1
[ADA Standards § 4.30.6] Yes No If No, install a sign with raised characters and Braille on the wall adjacent to the latch side of the door and centered 60 inches above the...
-
1009.2.4 Seat Height
The height of the lift seat shall be designed to allow a stop at 16 inches (405 mm) minimum to 19 inches (485 mm) maximum measured from the deck to the top of the seat surface when in the...
-
§ 38.125(c)(7) Stowage
including portable ramps or bridge plates stowed in the passenger area, do not impinge on a passenger's wheelchair or mobility aid or pose any hazard to passengers in the event of a sudden stop...
-
§ 38.83(c)(7) Stowage
including portable ramps or bridges plates stowed in the passenger area, do not impinge on a passenger's wheelchair or mobility aid or pose any hazard to passengers in the event of a sudden stop...
-
§ 38.95(c)(7) Stowage
including portable ramps or bridge plates stowed in the passenger area, do not impinge on a passenger's wheelchair or mobility aid or pose any hazard to passengers in the event of a sudden stop...
-
Reach Range
The appliance industry called attention to certain types of doors that, when fully open, cannot easily meet this specification, such as dishwasher doors and doors of ovens and broilers that...
-
11B-410.7 Landing size
ETA Editor's Note There are no requirements for landing size in 2010 ADA Standards, although the door maneuvering clearance requirements at 404.2.4 should be applicable outside the platform...
-
Gates
In the proposed rule, section 404 referenced doors and doorways....
-
Trailers with Single Wheel
Maneuverability of the bicycle is not generally affected, but stopping distances are naturally increased due to the excess weight....
-
F105.2.1 ANSI/BHMA
ANSI/BHMA A156.10-1999 American National Standard for Power Operated Pedestrian Doors (see 404.3)....
-
105.2.1 ANSI/BHMA
ANSI/BHMA A156.10-1999 American National Standard for Power Operated Pedestrian Doors (see 404.3)....
-
105.2.1 ANSI/BHMA
ANSI/BHMA A156.10-1999 American National Standard for Power Operated Pedestrian Doors (see 404.3)....
-
[2010 ADAS] 105.2.1 ANSI/BHMA
ANSI/BHMA A156.10-1999 American National Standard for Power Operated Pedestrian Doors(see 404.3)....
-
[2010 ADAS] 105.2.1 ANSI/BHMA
ANSI/BHMA A156.10-1999 American National Standard for Power Operated Pedestrian Doors (see 404.3)....
-
d. ii.
easy to grasp with one hand and does not require tight grasping and twisting actions of the wrist to operate at the following locations: (1) Main Lobby men's and women's toilet stall doors...
-
810.4 Bus Signs
EXCEPTION: Bus schedules, timetables and maps that are posted at the bus stop or bus bay shall not be required to comply....
-
7. What if I am being harassed because of my condition?
You should tell your employer about any harassment if you want the employer to stop the problem. Follow your employer's reporting procedures if there are any....
-
Recessed Lavatories
In-swinging doors must clear fixture clearances and door clearances must clear the water closet fixture (verify toilet length)....
-
4.10.12(4)
Controls shall be located on a front wall if cars have center opening doors, and at the side wall or at the front wall next to the door if cars have side opening doors (see Fig. 23(c) and...
-
4.10.12(4)
Controls shall be located on a front wall if cars have center opening doors, and at the side wall or at the front wall next to the door if cars have side opening doors (see Fig. 23(c) and...
-
804.6.2 Operable Parts
Appliance doors and door latching devices shall not be required to comply with 309.4. 2....