Grab bar backing shall be installed horizontally to permit the installation of a 48-inch (1219 mm) grab bar with each end 6 inches (152 mm) maximum from the end walls of the bathtub....
Search Results "Permitted Transfer"
Filters
Commonly Searched Documents
-
11B-809.10.5.2 Reinforcement for grab bars
-
Section 1630.14(b) Employment Entrance Examination
Section 1630.14(b) Employment Entrance Examination An employer is permitted to require post-offer medical examinations before the employee actually starts working....
-
Toilet Room Doors
Sections 4.22.2 and 4.22.3 of the 1991 Standards and Section 603.2.3 of the 2010 Standards permit the doors of all toilet or bathing rooms with in-swinging doors to swing into the required...
-
Doors in a Series
The Model Barrier Code for Residential Swimming Pools, Spas, and Hot Tubs (ANSI/NSPI−8 1996) permits latch releases for chain link or picket fence gates to be above 54 inches....
-
11B-101.1 General
(2) For purposes of this section, a facility is designed and constructed for first occupancy after January 26, 1993, only – (i) If the last application for a building permit...
-
11B-101.1 General
(2) For purposes of this section, a facility is designed and constructed for first occupancy after January 26, 1993, only – (i) If the last application for a building permit...
-
11B-404.2.7 Door and gate hardware
Existing locks shall be permitted in any location at existing glazed doors without stiles, existing overhead rolling doors or grilles, and similar existing doors or grilles that are designed...
-
11B-101.1 General
(2) For purposes of this section, a facility is designed and constructed for first occupancy after January 26, 1993, only – (i) If the last application for a building permit or permit...
-
11B-404.2.7 Door and gate hardware
Exceptions: Existing locks shall be permitted in any location at existing glazed doors without stiles, existing overhead rolling doors or grilles, and similar existing doors or grilles...
-
Applicability
Applicability Individual with a Mobility Impairment - An individual with a mobility impairment is permitted to operate a Segway in a Federal building under the jurisdiction, custody or...
-
F) Library Services
If a library provides program accessibility through alternate means it must have policies that permit staff to carry out this policy....
-
11B-405.5 Clear width
Within employee work areas, the required clear width of ramps that are a part of common use circulation paths shall be permitted to be decreased by work area equipment provided that the...
-
T503 Passenger Access Routes
In the 2016 Non-Rail Vehicle Guidelines, passenger access routes (which were referred to as “accessible circulation paths” in the proposed rule) must provide clearances sufficient to permit...
-
11B-604.4 Seats
In residential dwelling units, the height of water closets shall be permitted to be 15 inches (381 mm) minimum and 19 inches (483 mm) maximum above the finish floor measured to the top of...
-
Common Requirements (R304.5) (Section-by-Section Analysis)
Grade breaks are not permitted on the surface of ramp runs and turning spaces. Surface slopes that meet at grade breaks must be flush....
-
Washing Machines; Clothes Dryers— Sections 214.2 and 214.3 of the 2010 Standards
The 2010 Standards, however, permit either top loading or front loading machines in such facilities (Section 214.2 Washing Machines; Section 214.3 Clothes Dryers)....
-
11B-502.2 Vehicle spaces
Exception: Van parking spaces shall be permitted to be 108 inches (2743 mm) wide minimum where the access aisle is 96 inches (2438 mm) wide minimum....
-
Furnishings and Equipment
Unless specifically permitted, access features required by the ADA Standards must be fixed or built-in even though portable alternatives may be available....
-
11B-604.4 Seats
In residential dwelling units, the height of water closets shall be permitted to be 15 inches (381 mm) minimum and 19 inches (483 mm) maximum above the finish floor measured to the top of...
-
11B-604.4 Seats
In residential dwelling units, the height of water closets shall be permitted to be 15 inches (381 mm) minimum and 19 inches (483 mm) maximum above the finish floor measured to the top of...
-
11B-502.2 Vehicle spaces
Exception: Van parking spaces shall be permitted to be 108 inches (2743 mm) wide minimum where the access aisle is 96 inches (2438 mm) wide minimum....
-
11B-406.6 Islands
Landings complying with Section 11B-406.5.3 and the accessible route shall be permitted to overlap. Islands shall have detectable warnings complying with Section 11B-705....
-
11B-502.1 General
Exception: Where parking spaces or access aisles are not adjacent to another parking space or access aisle, measurements shall be permitted to include the full width of the line defining...
-
M305.3.1.2 Diagnostic Equipment Containing a Wheelchair Space
On diagnostic equipment containing a wheelchair space and permitting pass-through from one end to the other, the length of the gripping surface on horizontal standing supports shall be at...