Handrail Extensions ADAAG addresses handrail height, diameter, and extensions provided to the end of the gangway....
Search Results "End Transfer Surface"
Commonly Searched Documents
-
Handrail Extensions
-
Taking Measurements
Taking Measurements Sloped Surfaces One way to measure slope is to use a 24-inch level with leveling bubble and a tape measure....
-
17. If a soil stabilizer was installed as part of the trail surface material, please indicate the product name.
If a soil stabilizer was installed as part of the trail surface material, please indicate the product name....
-
31. Please indicate the number of the complete replacements of the trail surface that you have already performed
Please indicate the number of the complete replacements of the trail surface that you have already performed (in total, so far):...
- ADA Solutions, Inc. Cast in Place Tactile Surface
-
M301.4.2 Clearance Around Base (Section-by-Section Analysis)
In addition, where the width of the examination surface is less than 26 inches, the clearance depth would be the full width of the examination surface. Id....
-
Introduction
Introduction The proposed guidelines for medical diagnostic equipment recommends a minimum transfer surface 30 in. (760mm) wide and 15 in. (381mm) deep. At the request of the U.S....
-
6.3 Minority Reports
6.3 Minority Reports Because the Advisory Committee did not achieve consensus on the recommendation for a minimum transfer surface height standard, U.S....
- Gamco Surface Mounted Hand Dryer - DR-5128
-
8.4 Improving Data Sources and Research
For example, the Committee was making recommendations about standards for transfer surfaces of certain sizes....
- Gamco Surface-Mounted Robe Hook Satin - 76717
-
T402.7 Edge Guards
Ramps and bridgeplates shall provide edge guards continuously along each side of the ramp or bridgeplate to within 3 inches (75 mm) of the end of the ramp or bridgeplate that is deployed...
- Bobrick Surface-Mounted Sharp Disposal B-350169
- Irwin Seating Company ADA Swing-Away Aisle Panels
-
References
References Axelson PW, Chesney D (April 1999): “Accessible Exterior Surfaces Technical Report,” USATBCB, Washington, DC....
-
11B-407.4.10.1 Location
Clearance between support rails and adjacent surfaces shall be 1½ inches (38 mm) minimum....
-
11B-407.4.10.1 Location
Clearance between support rails and adjacent surfaces shall be 1½ inches (38 mm) minimum....
-
11B-407.4.10.1 Location
Clearance between support rails and adjacent surfaces shall be 1½ inches (38 mm) minimum....
-
1134A.5 Bathtubs
floor space 48 inches parallel by 30 inches perpendicular (1219 mm by 762 mm) to the side of a bathtub or bathtub-shower combination to provide for the maneuvering of a wheelchair and transfer...
- Just Manufacturing Surface Mount Paper Towel Dispenser 400 Capacity
-
Benches [1011.2]
However, armrests on both ends of a bench could prevent a person using a mobility device from being able to transfer from the device onto the bench....
-
Executive Summary
Performing the task of transferring oneself from one surface to another is highly essential for wheeled mobility device users in order to accomplish everyday activities such as going to...
- American Specialties 9012 Surface Mounted Baby Changing Station
-
11B-502.6.3 Location
Signs shall be permanently posted either immediately adjacent to the parking space or within the projected parking space width at the head end of the parking space....