Technical standards are provided for doors, benches, and mirrors, with less stringent standards for alterations....
Search Results "Proposed Standard"
-
III-7.5190 Dressing and fitting rooms
-
11B-224.5 Dispersion
Access Board's Note to Reader: The Department of Justice’s ADA standards also require the following: Places of lodging. ...
-
11B-224.5 Dispersion
Access Board's Note to Reader: The Department of Justice’s ADA standards also require the following: Places of lodging. ...
-
11B-224.5 Dispersion
Access Board's Note to Reader: The Department of Justice’s ADA standards also require the following: §36.406(c) Places of lodging. ...
-
1 Introduction
Justice published its revised regulations for Titles II and III of the Americans with Disabilities Act of 1990 "ADA" in the Federal Register on September 15, 2010, which include the 2010 Standards...
-
1. Scope
covers the mathematical processing of longitudinal profile measurements to produce a pedestrian pathway roughness statistic called the Pathway Roughness Index (PRI). 1.2 This provides a standard...
-
16(a)(iii)
(iii) The hotel has the required number of rooms for guests with hearing impairments, as set forth in ADA Standards §§ 9.1.2 and 9.1.3, that comply with ADA Standards § 9.3....
-
Toilet and Bathing Rooms
Section 213 of the 2010 Standards sets out the scoping requirements for toilet and bathing rooms....
-
Issue: Historically Significant Facilities
If alterations are being made to a historically significant property, however, these changes must be made in conformance with the ADA Standards for Accessible Design, (“the Standards”) 28...
-
Introduction
The ADA requires that new construction and alterations to existing facilities comply with the ADA Standards for Accessible Design 1 (Standards)....
-
104 Conventions
Section 104.1 of the 2010 Standards notes that dimensions not stated as a “maximum” or “minimum” are absolute....
-
Introduction
True “construction industry tolerances” as defined by the ADA Standards, should not be confused with another concept that we call “Acceptable Measurements.” ...
-
§ 1194.25(e)
(e) When products provide auditory output, the audio signal shall be provided at a standard signal level through an industry standard connector that will allow for private listening. ...
-
G.3.ii. - Are some types of secure electronic equipment, such as secure telecommunications devices that are specifically designed to prevent eavesdropping and other forms electronic attack, subject to Section 508 requirements?
Unless an exception applies, these technologies are considered EIT and must meet the Access Board standards....
-
1. PURPOSE
This document sets standards for facility accessibility by physically handicapped persons for Federal and federally-funded facilities....
-
11B-407.2.2.4 Reserved
ETA Editor's Note Lacking certain Exceptions allowed by 2010 ADA Standards, and imposing additional requirements regarding visible signals, the preceding CBC requirements pertaining...
-
Appendix 4 – References
Sydney, Australia: Standards Australia International. Australian Standard. (1992)....
-
H.7 - Are hand held devices (palm tops, cell phones) covered by Section 508?
This technology is "electronic and information technology" covered by Section 508 and the Access Board's standards....
-
810 Transportation Facilities
Specifications in 810.2 for bus stops applied to "bus stop pads" in the proposed rule....
-
G. Women's Spa and Fitness Center Locker Room
Women's Spa and Fitness Center Locker Room (1) Defendants will convert the Swiss shower of the current Royal Suite spa massage treatment room to a roll-in shower, pursuant to 2010 Standards...
-
BHMA
for Power Assist and Low Energy Power Operated Doors 1010.1.4.2, 11B-404.2.9, 11B-404.3, 11B-408.3.2.1, 11B-409.3.1 [2010 ADA Standards] 105.2.1 ANSI/BHMA....
-
11B-505.5 Clearance
[2010 ADA Standards] 505.5 Clearance. Clearance between handrail gripping surfaces and adjacent surfaces shall be 1½ inches (38 mm) minimum....
-
11B-505.5 Clearance
[2010 ADA Standards] 505.5 Clearance. Clearance between handrail gripping surfaces and adjacent surfaces shall be 1½ inches (38 mm) minimum....
-
1630.1(c)(1)
Except as otherwise provided in this part, this part does not apply a lesser standard than the standards applied under title V of the Rehabilitation Act of 1973 (29 U.S.C. 790 - 794a), or...