[ADA Standards § 4.30.6] Yes No If No, install a sign with raised characters and Braille on the wall adjacent to the latch side of the door and centered 60 inches above the...
Search Results "Doors in Series"
Commonly Searched Documents
-
H1
-
C) Accessible Entrance
If a door is provided, there must be maneuvering space on the pull and push sides of the door to permit a person using a wheelchair to open the door and then move through the door opening...
-
Reach Range
The appliance industry called attention to certain types of doors that, when fully open, cannot easily meet this specification, such as dishwasher doors and doors of ovens and broilers that...
-
11B-410.7 Landing size
ETA Editor's Note There are no requirements for landing size in 2010 ADA Standards, although the door maneuvering clearance requirements at 404.2.4 should be applicable outside the platform...
- AJW Architectural Products U510 Series U510-10 Sanitary Napkin/Tampon Dispenser - 10 cent Operation - Recessed
-
Gates
In the proposed rule, section 404 referenced doors and doorways....
-
F105.2.1 ANSI/BHMA
ANSI/BHMA A156.10-1999 American National Standard for Power Operated Pedestrian Doors (see 404.3)....
-
105.2.1 ANSI/BHMA
ANSI/BHMA A156.10-1999 American National Standard for Power Operated Pedestrian Doors (see 404.3)....
-
105.2.1 ANSI/BHMA
ANSI/BHMA A156.10-1999 American National Standard for Power Operated Pedestrian Doors (see 404.3)....
-
[2010 ADAS] 105.2.1 ANSI/BHMA
ANSI/BHMA A156.10-1999 American National Standard for Power Operated Pedestrian Doors(see 404.3)....
-
1133B.2.3.2
SECTION 1133B GENERAL ACCESSIBILITY FOR ENTRANCES, EXITS AND PATHS OF TRAVEL 1133B.2 Doors. 1133B.2.3.2 Automatic and power-assisted doors. ...
-
[2010 ADAS] 105.2.1 ANSI/BHMA
ANSI/BHMA A156.10-1999 American National Standard for Power Operated Pedestrian Doors (see 404.3)....
-
d. ii.
easy to grasp with one hand and does not require tight grasping and twisting actions of the wrist to operate at the following locations: (1) Main Lobby men's and women's toilet stall doors...
-
Recessed Lavatories
In-swinging doors must clear fixture clearances and door clearances must clear the water closet fixture (verify toilet length)....
-
4.10.12(4)
Controls shall be located on a front wall if cars have center opening doors, and at the side wall or at the front wall next to the door if cars have side opening doors (see Fig. 23(c) and...
-
4.10.12(4)
Controls shall be located on a front wall if cars have center opening doors, and at the side wall or at the front wall next to the door if cars have side opening doors (see Fig. 23(c) and...
-
AJW Architectural Products U236 Series Stainless Steel Roll Towel Dispenser - Recess Mounted
Door: #22 gauge stainless steel secured to cabinet body by means of a full length, heavy duty stainless steel piano type hinge along with a pin tumbler type lock, keyed like all other A&...
-
804.6.2 Operable Parts
Appliance doors and door latching devices shall not be required to comply with 309.4. 2....
-
804.6.2 Operable Parts
Appliance doors and door latching devices shall not be required to comply with 309.4. 2....
-
Alterations Affecting Primary Function Areas: ADA Standard Section 202.4
Section 202.4 covers the most current ADA Standards for alterations affecting primary function area.
- ADA Transition Planning - Part 2
-
11B-504.8 Floor identification
required by Chapter 10, Section 1023.9 complying with Sections 11B-703.1, 11B-703.2, 11B-703.3 and 11B-703.5 shall be located at the landing of each floor level, placed adjacent to the door...
- Pilot Rock XT and XTH Series End Accessible Picnic Table - Using Steel Tops and Seats
-
1023.9 Stairway identification signs
The bottom of the sign shall be located not less than 5 feet (1524 mm) above the floor landing in a position that is readily visible when the doors are in the open and closed positions....