from this study were obtained from a longitudinal study administered through the National Center on Accessibility (NCA) at Indiana University; One category of surface materials, constructed...
Search Results "Completion of Construction"
Commonly Searched Documents
-
Delimitations
-
V. Utilizing the 2010 Standards
These exceptions are necessary to ensure that HUD recipients construct or alter buildings and facilities with at least the same degree of accessibility as is currently required under HUD...
-
§100.205(e)(2)(v) 2003 International Building Code (IBC)
(v) 2003 International Building Code (IBC), if adopted without modification and without waiver of any of the provisions intended to address the Fair Housing Act's design and construction...
-
Accessible - Changes in Level
The maximum slope of a ramp in new construction shall be no greater than 1;12....
-
104 Conventions
A commenter stated that the 2010 Standards restrict the application of construction tolerances only to those few requirements that are expressed as an absolute dimension....
-
Passing Spaces [1016.4]
resting intervals overlap, the technical requirements for resting intervals apply and the slope of the surface must be no steeper than 1:48 (2 percent) in any direction when the ORAR is constructed...
-
5. Ground Level PV Systems
See Section 7 - Path of Travel Requirements and Adjusted Construction Cost for policy guidance on the adjusted construction cost for compliance with path of travel requirements. ...
-
Areas of Rescue Assistance [4.1.3(9), 4.3.11]
Other spaces, such as individual offices, can be designed and constructed according to these specifications and used as an area of rescue assistance where approved by the appropriate local...
-
ADA+ Facilities Compliance Services
Design of “reasonable accommodations” to allow qualified employees with disabilities or potential employees to perform essential job functions ADA+ Training Train design, construction...
-
11B-224.8.2 More than 50-bed facilities
ETA Editor's Note The following Access Board Note was taken from ADA Title II §35.151(e) New Construction and Alterations; Social Service Center Establishments, and ADA Title III §36.406...
-
1. Executive Summary
We are required by section 502 of the Rehabilitation Act to establish and maintain accessibility guidelines for the design, construction, and alteration of facilities covered by the Americans...
-
General: ADA Standard Section 214.1
Section 214.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for washing machines and clothes dryers.
-
Load and Unload Areas: ADA Standard Section 206.2.9.1
Section 206.2.9.1 covers scoping requirements in the most current ADA Standards for accessible routes to load and unload areas of amusement rides.
-
Height: ADA Standard Section 611.4
Section 611.4 covers the current ADA Standards for the height of the laundry compartment in top loading machines and front loading machines.
-
General: ADA Standard Section 303.1
Section 303.1 of the ADA Standards covers information in the current ADA Standards for changes in level for floor and ground surfaces.
-
General: ADA Standard Section 609.1
Section 609.1 of the ADA Standards covers information in the current ADA Standards for grab bars in toilet facilities and bathing facilities.
-
General: ADA Standard Section 213.1
Section 210.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for toilet facilities and bathing facilities.
-
General: ADA Standard Section 220.1
Section 220.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for automatic teller and fare machines.
-
General: ADA Standard Section 222.1
Section 222.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for dressing, fitting, and locker rooms.
-
Illumination: ADA Standard Section 407.4.5
Section 407.4.5 covers the current ADA Standards for the illumination of the elevator car controls, platform, car threshold and car landing sill.
-
General: ADA Standard Section 226.1
Section 226.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for dining surfaces and work surfaces.
-
1. Public Right-of-Way
Due to variations in workmanship and real-world construction practices, minor variations in the curb ramp or sidewalk construction may occur. 28 C.F.R. part 36, App....
-
The Blind Photographer
Requires the Registered User plan or above. Login!
-
207 Accessible Means of Egress
Provisions for accessible means of egress are completely revised in the final rule....
