. (§208.2) Yes No N/A Comments/Remedies A1 Is there at least one designated van accessible space with signage with the International Symbol of...
Search Results "Design Guideline"
-
Section A: Parking
-
2. Equipment Clearances for Breast Platforms
toe clearance requirements for diagnostic equipment used by patients seated in wheelchairs that paralleled the knee and toe clearance requirements from the 2004 ADA and ABA Accessibility Guidelines...
-
4.3.5.4 360-degree Turn
Thus, due to the potential impact, these findings require some policy decisions on who to exclude, or a new way to address this design issue....
-
1009.6.4 Separation
Each area of refuge shall be designed to minimize the intrusion of smoke. Exceptions: 1....
-
1009.6.4 Separation
Each area of refuge shall be designed to minimize the intrusion of smoke. Exceptions: 1....
-
ADAPTABLE
As part of the initial design and construction, for example, structural backing would be provided for the later installation of grab bars, base cabinets under kitchen sinks would be removable...
-
ADAPTABLE
As part of the initial design and construction, for example, structural backing would be provided for the later installation of grab bars, base cabinets under kitchen sinks would be removable...
-
407.4.7.1.2 Location
Raised character and braille designations shall be placed immediately to the left of the control button to which the designations apply....
-
Transfer Height
Transfer Height Ride seats designed for transfer must be between 14 and 24 inches above the load and unload area surface....
-
§ 35.171(a)(2)(i)
(i) If an agency other than the Department of Justice determines that it does not have section 504 jurisdiction and is not the designated agency, it shall promptly refer the complaint to...
-
407.4.7.1.2 Location
Raised character and braille designations shall be placed immediately to the left of the control button to which the designations apply....
-
§ 35.171(a)(2)(i)
(i) If an agency other than the Department of Justice determines that it does not have section 504 jurisdiction and is not the designated agency, it shall promptly refer the complaint to...
-
SDC Bollard Post with Push Plate or Touch Panel
Bollard post provide visibility and meet accessibility guidelines. Practical solution for surface mount or in-ground installation....
-
American Specialties Snap Flange Concealed Mounting Grab Bar 3700-Series
FEATURES In compliance with strength requirements of ADA guidelines Bars fabricated of satin finish 18 Gauge type 304 stainless steel tubing....
-
TrueForm 30" ADA Floating Concrete Sink Wood Edge FLO-30W-ADA
Concrete Sink meets ADA Accessibility Guidelines Dimensions: 30"L x 21"W x 5"H This floating concrete sink takes on the beautiful detail of a wood grained edge and yet still maintains...
-
Vehicle Parking
Design Tip Determine how long the parking area should be....
-
6.1 Q...do the dwelling units on both the first and second stories have to be made accessible?
ground floor to be any floor of a building with an accessible entrance on an accessible route, the Fair Housing Act regulations recognize that certain buildings, based on the site and the design...
-
M101.3 Equivalent Facilitation
The use of alternative designs and technologies that result in substantially equivalent or greater accessibility than specified in the proposed standards is permitted....
-
Pilot Rock SQT3-4 Series Square Portable Table - Using Lumber or Recycled Plastic
The frame design includes our non-tip, non-trip, walk-through features. Tables offer 30" nom. table height; 18" nom. seat height....
-
Allegion Von Duprin 98/99 Series Exit Devices
Von Duprin designs and manufactures exit devices in accordance to ISO 9001 Quality Management System and meets or exceeds accepted U.S. domestic and International standards....
-
11B-104.1 Dimensions
Dimensions stated as a "maximum" or "minimum" provide a dimensional range for design purposes. ...
-
230 Two-Way Communication Systems
1991 Standards for Accessible Design 2010 Standards for Accessible Design What’s New/Different 230.1 General...
-
§1193.23(a)
shall evaluate the accessibility, usability, and compatibility of telecommunications equipment and customer premises equipment and shall incorporate such evaluation throughout product design...
-
11B-104.1 Dimensions
Dimensions stated as a "maximum" or "minimum" provide a dimensional range for design purposes. ...
