be combined for the purposes of determining the required number of accessible rooms and type of accessible bathing facility in accordance with Table 224.2 to section 224.2 of the 2010 Standards...
Search Results "Brand Standards"
Filters
Commonly Searched Documents
-
§ 36.406(c)(1)(i)
-
A4.10.12 Car Controls
Industry-wide standardization of elevator control panel design would make all elevators significantly more convenient for use by people with severe visual impairments....
-
E202.5 Undue Burden or Fundamental Alteration
Where an agency determines in accordance with E202.5 that conformance to requirements in the 508 Standards would impose an undue burden or would result in a fundamental alteration in the...
-
Seat [4.21.3]
Minimum dimensions contained in the CABO-ANSI A117.1‒1992 standard are acceptable....
-
Eliminating Hazards [4.26.4]
Extensions with bottom edges within 27 inches of the floor are detectable within the standard sweep of canes....
-
2.9.1 Natural Elements
However, safety regulations or Forest Service construction and maintenance standards may define clear space and limit the allowable extension of natural protruding objects over the ORAR...
-
§1630.2(j)(1)(iv)
However, in making this assessment, the term “substantially limits” shall be interpreted and applied to require a degree of functional limitation that is lower than the standard for “substantially...
-
Trailer Bicycles
These devices consist of a single-wheel "half bike" in a child's size that can be attached to the back of a standard adult bicycle (or a tandem). These devices are relatively rare....
-
Is there a limit on the total length (number of runs) a ramp may have?
No, the Standards limit the rise of each run (30” max.), but not the overall length of ramps comprised of multiple runs....
-
How are parking spaces and access aisles to be marked?
The ADA Standards do not specify the method or color of parking space and access aisle markings. State or local codes and regulations may specify such markings....
-
11B-410.7 Landing size
ETA Editor's Note There are no requirements for landing size in 2010 ADA Standards, although the door maneuvering clearance requirements at 404.2.4 should be applicable outside the platform...
-
Existing play areas. (Section-by-Section Analysis)
These guidelines filled a void left by the 1991 Standards....
-
11B-206.2.8 Employee work areas
[2010 ADA Standards] 1....
-
11B-221.1 General
[2010 ADA Standards] 221.1 General. Assembly areas shall provide wheelchair spaces, companion seats, and designated aisle seats complying with 221 and 802....
-
Promoting the status of women with disabilities | Bethany Hoppe | TEDxNashville
These local, self-organized events are branded TEDx, where x = independently organized TED event....
-
C. First Advance Notice of Proposed Rulemaking (2010)
General Based on the TEITAC Report, the Board developed an Advance Notice of Proposed Rulemaking in 2010 (2010 ANPRM) to update the 508 Standards as well as the 255 Guidelines....
-
4.2 Stretchers
The MDE Advisory Committee therefore included stretchers among MDE requiring consideration in setting accessibility standards....
-
John Brabyn, Ph.D., Director of Rehabilitation Engineering Research, Center on Low Vision and Blindness (NIDRR), Smith-Kettlewell Eye Research Institute
Introduction Some Vision Research Relevant to Built Environment Codes & Standards (slide 1) Research is being funded by NIH/NEI. No standardized tests for glare....
-
Organization of This Rule
Throughout this rule, the original ADA Standards, which are republished as Appendix D to 28 CFR part 36, will be referred to as the ‘‘1991 Standards.’’...
-
Table 3
Proposed Guidelines Contain Requirements Not in DOJ 2010 Standards Table 3 analyzes requirements in the proposed guidelines for which there are no corresponding requirements in the DOJ...
-
68.74. Continuing Education
topics: (A) Texas Government Code, Chapter 469, Elimination of Architectural Barriers (B) 16 Texas Administrative Code, Chapter 68 – Administrative Rules; (C) Texas Accessibility Standards...
-
Plan 3B: 12-Foot Wide Accessible Guest Room
Plan 3B: 12-Foot Wide Accessible Guest Room This drawing shows an accessible 12-foot wide guest room with features that comply with the 2010 Standards....
-
Plan 2A: 13-Foot Wide Accessible Guest Room
Plan 2A: 13-Foot Wide Accessible Guest Room This drawing shows an accessible 13-foot wide guest room with features that comply with the 2010 Standards....
-
Alterations to Residential Facilities
The 2010 Standards, at sections 202.3 Exception 3, 202.4, and 233.3, contain specific scoping requirements for alterations to dwelling units....
