Support rails complying with Section 11B-407.4.10 shall be provided on at least one wall of the car....
Search Results "Control End Wall"
-
11B-411.4.10 Support rail
-
11B-813.2.1 Adult changing table
Adult changing tables shall be fixed to the floor or a wall and shall comply with Section 11B-813.2.1....
-
M301.2.3 Transfer Sides
The configuration of stretchers will not allow for unobstructed access to a transfer surface located at either the foot end or head....
-
1. Sloped Surfaces
Rest one end of the level at the highest point of the sloped surface and lift the other end (see below) until the bubble is in the middle of the tube. This is the “level” position....
-
11B-234.3 Minimum number
Exceptions: Amusement rides that are controlled or operated by the rider shall not be required to comply with Section 11B-234.3....
-
11B-234.3 Minimum number
Exceptions: Amusement rides that are controlled or operated by the rider shall not be required to comply with Section 11B-234.3....
-
Re: Lavatories Adjacent to Partitions
I would argue that it is a stretch of code definitions to interpret the face of a paper towel dispenser to be considered a 'wall or partition'....
-
11B-104.1.1 Construction and manufacturing tolerances
All dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific minimum and maximum end points....
-
§382.143(b)
or more passenger seats, you must provide training meeting the requirements of §382.141(a) for all personnel who deal with the traveling public in connection with flights that begin or end...
-
M304.2.2 Standing Supports
EXCEPTION: Diagnostic equipment with entry and exit permitting pass-through from one end to the other shall be permitted to provide one standing support on one side of the standing surface...
-
§27.1 Purpose.
The purpose of this part is to carry out the intent of section 504 of the Rehabilitation Act of 1973 (29 U.S.C. 794) as amended, to the end that no otherwise qualified individual with a...
-
§104.45(a) Housing provided by the recipient
At the end of the transition period provided for in subpart C, such housing shall be available in sufficient quantity and variety so that the scope of handicapped students' choice of living...
-
R305.2 Placement
Where the back of curb edge is tooled to provide a radius, the border dimension should be measured from the end of the radius....
-
§ 38.113(a)(2)
(2) Doorways at ends of cars connecting two adjacent cars, to the maximum extent practicable in accordance with regulations issued under the Federal Railroad Safety Act of 1970 (49 CFR parts...
-
Kitchens and Kitchenettes
Section 4.34.6 requires a clearance between opposing base cabinets, counters, appliances, or walls of at least 40 inches except in a U-shaped kitchen where the minimum clearance is 60 inches...
-
2. Background
These accessibility guidelines would adopt the definition of sidewalk in the Manual on Uniform Traffic Control Devices (MUTCD)....
- Bradley 3-Station Express Lavatory System MG-3
- Bradley 2-Station Express Lavatory System MG-2
- Federal Elevator 360 Passenger Elevator
-
1007.6.3 Two-way communication
Areas of refuge shall be provided with a two-way communication system between the area of refuge and a central control point....
-
1003.2.13.5.3 Two-way communication
Areas of refuge shall be provided with a two-way communication system between the area of refuge and a central control point....
- Bobrick Surface-Mounted Toilet Tissue Dispenser for Two Rolls B-27460
-
H18
Is the centerline of the toilet 18 inches from the adjacent side wall? [ADA Standards § 4.16.2; 4.17.3] Yes No...