Exceptions: Where the surface of the accessible route, clear floor or ground spaces, or turning spaces serving water play components is submerged, compliance with Sections 11B-302,...
Search Results "Compliance Date"
-
11B-1008.2.3 Water play components
-
11B-207.1 General
The IEBC is not adopted by the Division of the State Architect for access compliance. Therefore the provision will now be located in Section 11B-207.1. ◼...
-
11B-809.5.2 Residential dwelling unit smoke detection system and carbon monoxide detection system
ETA Editor's Note The lengthy California Building Code Chapter 9, Section 907.2.11 referenced above is not adopted by Division of the State Architect - Access Compliance (DSA-AC), and...
-
2. Types of Electronic Respiratory Assistive Devices
In addition, section 382.9 allows a foreign carrier to petition the Department for a waiver of compliance with any provision in Part 382, including section 382.133, if an applicable foreign...
-
Are the elements of path of travel and accessible routes substantively the same (such as slope, vertical clearance, width of path of travel, etc.)?
These elements are required to comply with the current code requirements or be brought into compliance when an alteration occurs....
-
3.2.2.1. Low Accessibility Baseline
in 2015** = Low Access-ibility Baseline Number of Audito-riums Exhibiting Digital Movies Equipped to Provide Captioning/ Audio Description in Compliance...
-
NOTES
See Architectural and Transportation Barriers Compliance Board. Notice of Proposed Rulemaking: Medical Diagnostic Equipment Accessibility Standards, 77 Fed....
-
c. Estimated Number and Type of Small Entities in the Movie Exhibition Industry
Option 1 would delay the compliance date for analog screens for four years after publication of the final rule. ...
-
Boat Slip Clearance: ADA Standard Section 1003.3.1
be permitted to be located perpendicular to the boat slip and shall extend the width of the boat slip, where the facility has at least one boat slip complying with 1003.3, and further compliance...
-
Construction and Manufacturing Tolerances: ADA Standard Section 104.1.1
Section 104.1.1 of the ADA Standards covers the most current information on dimensions in regards to construction and manufacturing tolerances in the ADA Standards.
-
11B-1003.3.1 Boat slip clearance
permitted to be located perpendicular to the boat slip and shall extend the width of the boat slip, where the facility has at least one boat slip complying with Section 11B-1003.3, and further compliance...
-
11B-1003.3.1 Boat slip clearance
permitted to be located perpendicular to the boat slip and shall extend the width of the boat slip, where the facility has at least one boat slip complying with Section 11B-1003.3, and further compliance...
-
4.2 Existing Facilities.
An airport operator is not required to make structural changes to existing facilities where other methods are effective in achieving compliance....
-
101.2 Effect on Removal of Barriers in Existing Facilities
Removal of architectural barriers, pursuant to 28 C.F.R. s. 36.304, from buildings, structures or facilities shall comply with this code’s requirements for alterations unless compliance...
-
Fact Sheet: Highlights of the Final Rule to Amend the Department of Justice's Regulation Implementing Title III of the ADA
Architectural and Transportation Barriers Compliance Board (Access Board)....
-
11B-1008.2.3 Water play components
Where the surface of the accessible route, clear floor or ground spaces, or turning spaces serving water play components is submerged, compliance with Sections 11B-302 _|Floor or Ground...
-
16. What should an employer do when another federal law prohibits it from hiring anyone with a hearing impairment?
The employer should be certain, however, that compliance with the law actually is required, not voluntary....
-
Additional Information
Medical Leave Act, the Americans with Disabilities Act, and Title VII of the Civil Rights Act of 1964, www.eeoc.gov/policy/docs/fmlaada.html (see "Comparison of ADA and FMLA Leave" and "ADA Compliance...
-
11B-224.7 Housing at a place of education
Multi-bedroom housing units containing accessible sleeping rooms with mobility features shall have an accessible route throughout the unit in compliance with Section 11B-809.2....
-
Trash and Recycling Receptacles [1011.2 and 1011.3]
Until products with compliant operable parts become commercially available, compliance is required to the extent practicable....
-
Principle of Reasonableness and Cost
In the preamble to the proposed guidelines, the Department stated in relevant part as follows: "These guidelines are intended to provide a safe harbor for compliance with respect to those...
-
7. Alternatives
Comments received from the public indicated that this approach was potentially confusing, as federal agencies, contractors, and vendors would have to make specific compliance determinations...
-
Availability of Proposed Guidelines with Figures
In the past, the Architectural and Transportation Barriers Compliance Board (Access Board) submitted “camera ready” copy (i.e., images) of its guidelines to the Federal Register for the...