Standing supports that adjust from horizontal to vertical positions and at angles in between, such as a bar that folds up and locks into multiple positions, can be used....
Search Results "Adjustable Height Exam Table"
-
Standing Supports (M304.3 and M305.3)
-
1018.5 Obstacles
Obstacles on beach access routes and resting intervals shall not exceed 1/2 inch (13 mm) in height measured vertically to the highest point....
-
1018.5 Obstacles
Obstacles on beach access routes and resting intervals shall not exceed 1/2 inch (13 mm) in height measured vertically to the highest point....
- Sizewise SW Low Boy
-
F208.2.3.3 Parking for Guests, Employees, and Other Non-Residents
Where parking spaces are provided for persons other than residents, parking shall be provided in accordance with Table F208.2. [ECTCR UFAS 4.1.1(5)(d)(iii) re visitor parking only]...
-
12162(a)(4)(B)(i)
(i) if such train includes a bi-level lounge car purchased after July 26, 1990, table service in such lounge car shall be provided to individuals who use wheelchairs and to other passengers...
- Jack McClellan
- Big John Toilet Support & Short Swivel Support
- Inclusion Solutions Pakflatt® Franklin® Voting Booth
-
Sections 5 Through 9 (Preamble, Section-by-Section Analysis)
For example, at least 5 percent, but not less than one, of the fixed tables in a restaurant must be accessible....
-
Sections 5 Through 9 (Section-By-Section Analysis and Response to Comments)
For example, at least 5 percent, but not less than one, of the fixed tables in a restaurant must be accessible....
-
11B-1009.5.4 Transfer steps
Transfer step height shall be 8 inches (203 mm) maximum. The surface of the bottom tread shall extend to a water depth of 18 inches (457 mm) minimum below the stationary water level....
-
7. Should overhead play components such as track riders, ring ladders, monkey bars, and chin up bars be lowered to the recommended reach ranges?
It is recommended that, where possible, providing one component or element of a component at a lower height, or multiple overhead components at varied heights, would better accommodate more...
-
MEASUREMENT TECHNIQUE
MEASUREMENT TECHNIQUE The depth and width are measured along the centerlines of the seat, and the height from the floor to the highest point of the transfer surface: The depth...
-
1132A.4, Item 3
., concrete, brick, flagstone) may have a maximum change in height from the interior landing of 4 inches (101.6 mm)....
-
§ 38.53(d)(1) Requirements
vehicles shall be coordinated with the boarding platform design such that the horizontal gap between each vehicle door at rest and the platform shall be no greater than 3 inches and the height...
-
1009.5.4 Transfer Steps
Transfer step height shall be 8 inches (205 mm) maximum....
-
M101.5 Dimensions (Section-by-Section Analysis)
The only change to this provision was adjustment of the section number to allow for the addition of the new provision, M101.3 Existing Diagnostic Equipment....
-
5. Accessible Features
display racks and potted plants so they do not impede exterior and interior routes; snow removal on exterior routes; replacing damaged or stolen room identification signs; tightening or adjusting...
-
II-3.5400 Surcharges
It may, however, adjust its tuition or fees for all students....
-
11B-211.2 Minimum number
The 2013 California Plumbing Code (CPC), Table 4-1 provides minimum plumbing fixture requirements for new buildings, and changes of occupancy or use in an existing building resulting in...
-
Door Maneuvering Clearance
Table 404.2.4.1 specifies maneuvering clearances for manual swinging doors and gates....
-
Running Slope [1016.7.1]
To accommodate steep terrain, ORARs may be designed with shorter sections that have a steeper running slope and length, as shown in table 3, with resting intervals at the top and bottom...
-
11B-221.2.1.1 General seating
Wheelchair spaces complying with Section 11B-802.1 shall be provided in accordance with Table 11B-221.2.1.1. ...