Compliance with §38.125 of this part shall be required only to the extent necessary to meet the requirements of paragraph (d) of this section....
Search Results "ADA Compliance"
Filters
Commonly Searched Documents
-
§ 38.111(a)(1)
-
16(a)(v)
(v) The accessible rooms for individuals with mobility disabilities have the maneuvering clearances for beds specified in ADA Standards §9.2.2(1), to and within the bathroom (ADA Standards...
-
11B-705.1.2.2.2.2 Two entrance/exit points
Existing parallel curb ramps with detectable warnings in compliance with the code requirements in effect at the time of installation shall not be required to provide a minimum 36 inches...
-
11B-235.2.1 Dispersion
For example, a fuel pier may contain boat slips, and this type of short term slip would be included in determining compliance with Section 11B-235.2. ◼...
-
11B-404.3 Automatic and power-assisted doors and gates
An automatic door may be used as equivalent facilitation when it is technically infeasible to provide sufficient strike-side clearance for code compliance, but a power-assisted door may...
-
11B-233.3.4 Alterations
Exception: Where compliance with Sections 11B-809.2, 11B-809.3, or 11B-809.4 is technically infeasible, or where it is technically infeasible to provide an accessible route to a residential...
-
Can parking signage height be considered a "safe harbor"?
Architectural and Transportation Barriers Compliance Board, July 1998 “Accessible spaces must be designated by the access symbol, which can be mounted on walls, posts, or from garage...
-
Federal Publications
ADA Standards for Accessible Design ADA Update: A Primer for State and Local Governments A Guide to the ADA Standards for Accessible Design Accessibility of...
-
A. SCOPE OF THE INVESTIGATION
WHEREAS, this matter was initiated by a complaint filed under title II of the Americans with Disabilities Act of 1990 ("ADA"), 42 U.S.C. §§ 12131-12134, with the United States Department...
-
I. BACKGROUND
The FTA reviews grant applications for, among other things, compliance with the Americans with Disabilities Act (“ADA”)....
-
Introduction
Title I of the ADA prohibits disability-based discrimination in employment....
-
11B-806.2.5 Kitchens, kitchenettes and wet bars
[2010 ADA Standards] 806.2.5 Kitchens and Kitchenettes. Kitchens and kitchenettes shall comply with 804....
-
11B-303.2 Vertical
[2010 ADA Standards] 303.2 Vertical. Changes in level of ¼ inch high maximum shall be permitted to be vertical....
-
3001.3 Accessibility
108.2.1.2 regulated by the Department of Housing and Community Development or Chapter 11B for applications listed in Section 1.9.1 regulated by the Division of the State Architect─Access Compliance...
-
§104.9 Administrative requirements for small recipients.
fifteen employees, or any class of such recipients, to comply with §§104.7 and 104.8, in whole or in part, when the Assistant Secretary finds a violation of this part or finds that such compliance...
-
Section 3. Fair Housing Act Design and Construction Requirements
A reprint of §100.205 was included to provide easy reference to (1) the Act's accessibility requirements, as codified by §100.205; and (2) the additional examples of methods of compliance...
-
§8.57(a) General
If there appears to be a failure or threatened failure to comply with this part and if the noncompliance or threatened noncompliance cannot be corrected by informal means, compliance with...
-
1002.4.7.1 Shoulder-to-Shoulder Seating
EXCEPTION: Where shoulder-to-shoulder companion seating is not operationally or structurally feasible, compliance with this requirement shall be required to the maximum extent practicable...
-
Doors
Recommendation: Compliance with 4.13.6 is recommended because while wider door openings may facilitate access, they do not fully compensate for latch-side clearance, particularly on the...
-
V. DEVELOPMENT OF DISABILITY-RELATED POLICIES AND PROCEDURES
A statement of compliance with Title III of the ADA and Section 504 generally; 2....
-
TownSteel ED1100 Grade 1 Panic Rim Device
Specify handing when required Finish US32D, US10B stocked, other upon request Trim Available in 200 and 300 series, sold separately CODE COMPLIANCE ANSI/BHMA A156.3-2008 Grade...
-
TownSteel ED1400 Grade 1 Mortise Panic Device
Specify handing when required Finish US32D, US10B stocked, other upon request Trim Available in 200 and 300 series, sold separately CODE COMPLIANCE ANSI/BHMA A156.3-2008 Grade 1...
-
Reasonable Accommodation Management Software
We purposefully built the RAMS (Reasonable Accommodation Management Software) to lessen the time and energy you spend on RA compliance under FMLA and ADA Title I....
-
9. Release of Claims
Released Claims Up to the Commencement of the Compliance Period Effective upon the entry of Judgment by the District Court, Plaintiffs and the Settlement Class members (and their respective...
