Clear floor or ground space is required around the usable sides of each constructed feature, but the size of the clear space varies with the feature....
Search Results "Side Entry"
Filters
Commonly Searched Documents
-
Providing Comforts and Conveniences—Constructed Features
-
1115B.3.2, Item 3
The centerline of the water closet fixture shall be18 inches (457 mm) from the side wall or partition....
-
(4) Adjustability: Method of Measurement
The MDE NPRM proposed that the measurement of the height of the transfer surface for both diagnostic equipment used in the supine, prone, or side-lying position and diagnostic equipment...
-
R208 Detectable Warning Surfaces (Section-by-Section Analysis)
the edges of the boarding platform are not protected by screens or guards; and Boarding and alighting areas at sidewalk or street level transit stops for rail vehicles where the side...
-
2. Typical Issues for People Who are Blind or Have Low Vision
Objects that are wall mounted, that project into a pedestrian route from the side, or that are overhead must be located so that individuals who are blind or have low vision will either detect...
-
Part 2. Typical Issues for Voters Who are Blind or Who Have Low Vision
Objects that are wall-mounted, that project into a pedestrian route from the side, or that are overhead must be located so that voters who are blind or who have a visual impairment will...
-
Types of Alternative Designs
Swing-away grab bars were typically located on both sides of the toilet rather than fixed grab bars on the side and rear walls as indicated in ADAAG....
-
Dancing Dots - Valley Forge, PA
Music scanning software can be used to speed data entry....
-
Reach Range
A specification that these controls be to the side of the door has been removed in the final rule as unnecessarily restrictive....
-
Sections 4.8.5 and 4.9.4
Section 505.6 requires handrail gripping surfaces to be continuous along their length and not to be obstructed along their tops or sides....
-
611 Washing Machines and Clothes Dryers
This dimension stems from specifications for obstructed side reaches (308.3)....
-
Installation Issues
Braille (right side up!) Issue 11. Good vibrations (vibrotactile indications) Issue 12. Audible beaconing Issue 13. Stub poles Issue 14....
-
Q3.) What are the types of “manufacturing processes” that were anticipated where the advisory says “tolerances recognized by this provision include… “those that may be a necessary consequence of a particular manufacturing process”?
To simplify the tolerance assessment, the 2010 Standards specify that the shower compartment be measured at the center points of opposing sides but the expectation is that the width at the...
-
Medical Diagnostic Equipment Accessibility Standards Sub-Committee Recommendations Imaging Equipment
Especially, Section M301, Diagnostic Equipment Used by Patients in Supine, Prone, or Side-Lying Position....
-
C. Chapter 3: Technical Requirements (Section-by-Section Analysis)
requirements for accessible medical diagnostic equipment based on how the diagnostic equipment is used by the patients, including: diagnostic equipment used by patients in a supine prone, or side-lying...
-
R306.3 Roundabouts
Pedestrian street crossings at roundabouts can be difficult for pedestrians who are blind or have low vision to identify because the crossings are located off to the side of the pedestrian...
-
Areas of sport activity. (Section-by-Section Analysis)
In court sports, the accessible route would also have to directly connect both sides of the court. ...
-
H29
If a coat hook is provided is it mounted no higher than 54 inches above the floor for a side approach or 48 inches above the floor for a front approach?...
-
1009.4.5 Grab Bars
Where one grab bar is provided, clearance shall be 24 inches (610 mm) minimum on both sides of the grab bar....
-
406.7 Islands
Raised islands in crossings shall be cut through level with the street or have curb ramps at both sides....
-
1009.5.7 Grab Bars
Grab bars shall comply with 609 and be located on at least one side of the transfer system. The grab bar located at the transfer platform shall not obstruct transfer....
-
1132A.9 Smooth surface
Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
