Search Results "Side Transfer"

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM
  Transfer Surface

  Part of diagnostic equipment onto which patients who use mobility devices or aids transfer when moving onto and off of the equipment....

• Federal Documents > Preamble to Guidelines > 36 CFR Parts 1190 and 1191 ADA and ABA Accessibility Guidelines - Preamble (Discussion of Comments and Changes)
  Sides of Curb Ramps

  Section 406.3 addresses the sides of curb ramps and specifies that side flares, where provided, have a slope of 1:10 maximum....

• Federal Documents > Technical Assistance > Outdoor Developed Areas: A Summary of Accessibility Standards for Federal Outdoor Developed Areas
  Transfer Access [1014.2.1]

  To provide transfer access at the entrance to a camp shelter, a clear ground space at least 36 by 48 inches positioned for a parallel approach must be provided along the open side of the...

• State and Local Documents > Codes and Standards > 2013 California Standards for Accessible Design Pocket Guide
  11B-1002.6.2 Transfer height

  The height of transfer device seats shall be 14 inches (356 mm) minimum and 24 inches (610 mm) maximum measured from the load and unload surface....

• Research and History > Research Documents > Independent Wheelchair Transfers in the Built Environment: How Transfer Setup Impacts Performance Phase 2: Final Report
  Transfer Protocols

  For each transfer, participants were asked to position themselves next to the platform as they normally would to prepare for a transfer....

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.1.4 Transfer Surface Height Measurement for M301 and M302

  5.1.4 Transfer Surface Height Measurement for M301 and M302 The Committee recommends capturing the transfer surface height at the highest point of the seat in an uncompressed state, inclusive...

• State and Local Documents > Codes and Standards > 2013 California Standards for Accessible Design Pocket Guide
  11B-1008.3.1 Transfer platforms

  Transfer platforms shall be provided where transfer is intended from wheelchairs or other mobility aids. Transfer platforms shall comply with Section 11B-1008.3.1....

• State and Local Documents > Codes and Standards > 2016 California Standards for Accessible Design Pocket Guide - Eff. Jan. 1, 2017
  11B-1008.3.1 Transfer platforms

  Transfer platforms shall be provided where transfer is intended from wheelchairs or other mobility aids. Transfer platforms shall comply with Section 11B-1008.3.1....

• State and Local Documents > Codes and Standards > 2019 California Standards
  11B-1008.3.1 Transfer platforms

  Transfer platforms shall be provided where transfer is intended from wheelchairs or other mobility aids. Transfer platforms shall comply with Section 11B-1008.3.1....

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M301.2.3.1 End Transfer Surface

  End transfer surfaces shall be 28 inches (710 mm) wide minimum and 17 inches (430 mm) long minimum. ...

• State and Local Documents > Codes and Standards > 2012 Florida Accessibility Code
  1008.3.2 Transfer Steps

  1008.3.2 Transfer Steps....

• Federal Documents > Standards > ABA Accessibility Standard for GSA Facilities Pocket Guide
  1008.3.2 Transfer Steps

  Transfer steps shall be provided where movement is intended from transfer platforms to levels with elevated play components required to be on accessible routes....

• State and Local Documents > Codes and Standards > 2012 Texas Accessibility Standards
  1008.3.2 Transfer Steps

  Transfer steps shall be provided where movement is intended from transfer platforms to levels with elevated play components required to be on accessible routes....

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  4.3.2 Transfer Surfaces and Imaging Equipment Functions

  4.3.2 Transfer Surfaces and Imaging Equipment Functions The transfer surface (table) of diagnostic imaging equipment serves two purposes: (1) it allows patients to be positioned properly...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.2 Transfer Surface Size for Equipment Used by Patients in Supine, Prone, or Side-Lying Position

  5.2 Transfer Surface Size for Equipment Used by Patients in Supine, Prone, or Side-Lying Position....

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.2.1.2 Transfer Surface Depth Recommendation for M301

  5.2.1.2 Transfer Surface Depth Recommendation for M301 The Committee recommends a minimum transfer surface depth of 17 inches for all M301 except imaging equipment....

• State and Local Documents > Codes and Standards > 2022 California Standards
  11B-1008.3.2.4 Contrasting stripe

  Striping complying with Section 11B-504.4.1 shall be provided at each transfer step....

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.1.1 Transfer Surface Height Adjustability

  5.1.1 Transfer Surface Height Adjustability. The transfer surface should have an adjustable height in small virtually continuous increments....

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.1.2 Transfer Surface High Height

  5.1.2 Transfer Surface High Height. The transfer surface should have an adjustable height range with an upper height measuring at least 25 inches....

• Federal Documents > Preamble to Guidelines > 36 CFR Part 1191 ABA Accessibility Guidelines, Outdoor Developed Areas - Preamble
  1014.2.1 Transfer Access

  Where transfer access is provided, this section requires a clear ground space 36 inches minimum by 48 inches minimum positioned for a parallel approach to be provided at the entrance to...

• Federal Documents > Standards > 36 CFR Part 1194 - Information and Communication Technology (ICT) Final Standards and Guidelines (with amendments issued through Jan. 2018)
  407.8.1.1 Vertical Plane for Side Reach

  Where a side reach is provided, the vertical reference plane shall be 48 inches (1220 mm) long minimum....

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1194 - Proposed Information and Communication Technology (ICT) Standards and Guidelines NPRM
  407.12.1.1 Vertical Plane for Side Reach

  Where a side reach is provided, the vertical reference plane shall be 48 inches (1220 mm) long minimum....

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM - Preamble
  Additional Technical Criteria Considered for Transfer Supports

  As discussed below, the Access Board is considering whether additional technical criteria would be appropriate for transfer supports....

• Legal Documents > United States of America v. Hilton Worldwide Inc. - Consent Decree
  (5) Bricks and Mortar Transfers

  (5) Bricks and Mortar Transfers: A transfer of interest in the Brand Hotel in which, after completion of the transaction, the pre-transfer hotel owner retains management control of hotel...