[2010 ADAS] EXCEPTION: In existing sites, buildings, and facilities, ramps shall be permitted to have running slopes steeper than 1:12 complying with Table 405.2 where such slopes are...
Search Results "Site Analysis Test"
Filters
Commonly Searched Documents
-
11B-405.2 Slope
-
Is compliance required for parking spaces designed specifically for recreational vehicles such as motor homes and camping or boating trailers?
The ABA Standards, which apply to federally funded sites, provide requirements for outdoor developed areas on federal lands such as camping and picnic facilities that include provisions...
-
11B-405.2 Slope
[2010 ADAS] EXCEPTION: In existing sites, buildings, and facilities, ramps shall be permitted to have running slopes steeper than 1:12 complying with Table 405.2 where such slopes are...
-
11B-405.2 Slope
[2010 ADA Standards] EXCEPTION: In existing sites, buildings, and facilities, ramps shall be permitted to have running slopes steeper than 1:12 complying with Table 405.2 where such...
-
Inpro Corporation Endurant® Stainless Steel Folding Grab Bar
Features and Benefits Stainless Steel Folding Grab bar comes with a satin finish Easily folds out either way ADA compliant and tested to withstand 220 lbs...
-
Technically Infeasible
because existing structural conditions would require removing or altering a load-bearing member that is an essential part of the structural frame; or because other existing physical or site...
-
1.3 General Exceptions
Sites, buildings, facilities and elements are exempt from these requirements to the extent specified by Section 11B-203."...
-
ASME: ADA Standard Section 105.2.2
Section 105.2.2 of the ADA Standards cover references to the American Society of Mechanical Engineers (ASME) standards.
-
SECTION 504 OF THE REHABILITATION ACT OF 1973 POLICY INTERPRETATION NO. 3
individuals will be entitled to services by a given recipient, and for other reasons set forth below, the absence of mobility impaired persons residing in an area cannot be used as the test...
-
Residential Facilities
which are covered by a single contract for federal financial assistance or application for assistance, or are treated as a whole for processing purposes, whether or not located on a common site...
-
Compliance requirements
The Section-by-Section Analysis of the preamble describes the proposed accessibility guidelines....
-
Significant alternatives
The Access Board will prepare a final regulatory flexibility analysis when the final standards are issued that discusses any significant alternatives considered....
-
Deltrex Hand/Foot Push Plate Switches
Features All manufactured with rust resistant 1/4" inch aluminum Non-binding internal stainless steel screws Tested for 1,000,000,000 pushes...
-
Deltrex S106 Series Push Plate Switch
Features All manufactured with rust resistant 1/4" inch aluminum Non-binding internal stainless steel screws Tested for 1,000,000,000 pushes...
-
Taking Photographs
It is always useful to first take a photo that will clearly identify the site, then the elements surveyed....
-
F216.5 Parking
Where a total of four or fewer parking spaces, including accessible parking spaces, are provided on a site, identification of accessible parking spaces shall not be required. 2. ...
-
C. Food Service
At each food service establishment on this site where food and/or drink is served for consumption (i.e.: direct counter service) at counters or bars, is there a minimum 60" long portion...
-
216.5 Parking
Where a total of four or fewer parking spaces, including accessible parking spaces, are provided on a site, identification of accessible parking spaces shall not be required. 2....
-
Bookmarks
Bookmark emergency resource mobile sites so you can quickly access them....
-
Disproportionality (20%)
The 20% cap applies only to costs associated with the accessible path of travel, including an accessible route to the primary function area from site arrival points, entrances, and retrofits...
-
TECHNICALLY INFEASIBLE
because the existing structural conditions require the removal or alteration of a load-bearing member that is an essential part of the structural frame, or because other existing physical or site...
-
TECHNICALLY INFEASIBLE
because the existing structural conditions require the removal or alteration of a load-bearing member that is an essential part of the structural frame, or because other existing physical or site...
-
709.5 Openings
mullion shall be installed having vision panels with approved fire-resistance-rated glazing materials in approved fire-resistance-rated frames, the area of which shall not exceed that tested...
-
What would happen with other disability groups?
Therefore, we would hypothesize that our results would also be similar if we had tested other disability populations or older adults....
