(illustration showing a van with a side-mounted wheelchair lift lowered onto a marked access aisle at a van-accessible parking space....
Search Results "Side Light"
Commonly Searched Documents
-
Van-Accessible Parking Spaces
-
11B-308.4 Suggested reach ranges for children
These dimensions apply to either forward or side reaches. ...
-
1132A.9 Smooth surface
Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
1132A.9 Smooth surface
Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
- Tork Image Design™ Matic® Hand Towel Roll Dispenser with Intuition® Sensor
- Delta Single Handle Vessel Lavatory Faucet with Touch20.xt Technology 751T-DST
- Kawneer North America 1010C Sliding Mall Front
- HEWI Range 250 Door Hardware
- Nana Wall Systems, Inc. Folding Glass Walls SL60
- BTX Intelligent Fashion Tumo Programming Reverse Motor Direction
- Hager Companies Door Protection Plate 190S
- Innerface Trio Interior Signage
- Hoyer Manual Hydraulic Lift
- Allegion LCN 4000 Series Surface Mounted Door Control
-
Reach Range
A specification that these controls be to the side of the door has been removed in the final rule as unnecessarily restrictive....
-
Sections 4.8.5 and 4.9.4
Section 505.6 requires handrail gripping surfaces to be continuous along their length and not to be obstructed along their tops or sides....
-
611 Washing Machines and Clothes Dryers
This dimension stems from specifications for obstructed side reaches (308.3)....
-
Power-Operated Doors or Gates
Those with doors or gates on opposing sides generally facilitate lift use by permitting a forward approach to both entry and exit doors or gates....
-
Installation Issues
Braille (right side up!) Issue 11. Good vibrations (vibrotactile indications) Issue 12. Audible beaconing Issue 13. Stub poles Issue 14....
-
Q3.) What are the types of “manufacturing processes” that were anticipated where the advisory says “tolerances recognized by this provision include… “those that may be a necessary consequence of a particular manufacturing process”?
To simplify the tolerance assessment, the 2010 Standards specify that the shower compartment be measured at the center points of opposing sides but the expectation is that the width at the...
-
Submerged Depth
Adding a solid wall on the side closest to the water can enhance safety....
-
Medical Diagnostic Equipment Accessibility Standards Sub-Committee Recommendations Imaging Equipment
Especially, Section M301, Diagnostic Equipment Used by Patients in Supine, Prone, or Side-Lying Position....
-
C. Chapter 3: Technical Requirements (Section-by-Section Analysis)
requirements for accessible medical diagnostic equipment based on how the diagnostic equipment is used by the patients, including: diagnostic equipment used by patients in a supine prone, or side-lying...
-
R306.3 Roundabouts
Pedestrian street crossings at roundabouts can be difficult for pedestrians who are blind or have low vision to identify because the crossings are located off to the side of the pedestrian...