Detectable warnings shall consist of raised truncated domes with a diameter of nominal 0.9 in (23 mm), a height of nominal 0.2 in (5 mm) and a center-to-center spacing of nominal 2.35 in...
Search Results "Adjustable Height Counter"
Filters
Commonly Searched Documents
-
4.29.2* Detectable Warnings on Walking Surfaces
-
Verify Rough Plumbing
Location of lavatory traps from side walls. 11B-606.6 Location of bathtub controls and drain. 11B-607.5 Installation height...
-
4.1.3 Wheelchair Seating Space
Toe clearance of at least 9 inches (230 mm) in height shall extend at least an additional 5 inches (125 mm) from the knee clearance....
-
Knee Clearance: Clearance as Measured from Anterior-Most Point - Manual Wheelchair
It references dimensions of clearance height and depth to the forward-most point on the person or mobility device (e.g., toe, footrest)....
-
Knee Clearance: Clearance as Measured from Dorsal Foot Point - Manual Wheelchair
It references dimensions of clearance height and depth to the dorsal foot point on a person (e.g., top of ankle)....
-
M303.2.4.2 Knee Clearance
Between 9 inches (230 mm) and 27 inches (685 mm) above the floor, the knee clearance shall be permitted to reduce at a rate of 1 inch (25 mm) in depth for every 6 inches (150 mm) in height...
-
11B-707.9.1.1 Tactilely discernible numerical keypad
A tactilely discernible numerical keypad similar to a telephone keypad containing a raised dot with a dot base diameter between 1.5 mm and 1.6 mm and a height between 0.6 mm and 0.9 mm on...
-
Rakks® Brackets Installation Video
Depending on length and load capacities, brackets are manufactured in 1-1/4” and 2” heights. Rakks Style brackets have excellent lateral support and work well as bookends....
-
Apex Challenge Circuit CH7000
An adjustable lap/leg restraint stabilizes the body to insure maximum intensity during the exercises....
-
4. Overhead PV Systems
See Section 7 - Path of Travel Requirements and Adjusted Construction Cost for policy guidance on the adjusted construction cost for compliance with path of travel requirements. ...
-
10. How does an employee with a hearing disability request a reasonable accommodation?
A person simply has to tell the employer that she needs an adjustment or change at work because of her hearing impairment....
-
3.14
modification(s) will be suspended while Cinemark and DOJ meet in a good faith effort to agree on a comparable substitute modification(s) that shall not result in costs in excess of 15%, adjusted...
-
M101.6 Dimensional Tolerances (Section-by-Section Analysis)
The only change to this provision was to adjust the section number to allow for the addition of a new section, M101.3 Existing Diagnostic Equipment....
-
M307 Operable Parts (Section-by-Section Analysis)
M307 in the final rule provides the technical criteria for operable parts used by patients to activate, deactivate, or adjust the diagnostic equipment....
-
PHYSICAL PROVISIONS
Alternatively, a response time may be required if it can be by-passed or adjusted by the user over a wide range (up to 10 times the average time)....
-
C) Accessible Entrance
If a door closer is provided, it must be adjusted so the door will not close too quickly....
-
502.4 Platform Accessibility Features (Section-by-Section Analysis)
addresses specifications for capabilities that users with disabilities have come to expect as core accessibility features when using today’s platforms and operating systems, such as allowing adjustment...
-
5. Conclusions
Some characteristics of the WC can be adjusted to minimize these WBVs such as adding suspensions systems, using larger more compliant wheels, etc....
-
11B-206.2.8 Employee work areas
Common use circulation paths located within employee work areas that are less than 1000 square feet (93 m2) and defined by permanently installed partitions, counters, casework, or furnishings...
-
Test Courses & Surfaces
Table 2 Reference Carpet and Pad Carpet Code Level loop, 100% nylon with a woven polypropylene backing; 0.16 in pile height; 28 oz pile weight C1...
-
4. Organization of Technical Criteria
equipment that is designed for use by patients seated in a wheelchair would have to meet the technical criteria for wheelchair spaces, changes in level at entry to the wheelchair space, and height...
-
b. A Qualified Person with a Disability
physical and communication barriers; and (3) providing auxiliary aids or services for effective communications.18 Essential eligibility requirements can include minimum age limits or height...
-
11B-604.5 Grab bars
Where separate grab bars are required on adjacent walls at a common mounting height, an L-shaped grab bar meeting the dimensional requirements of Sections 11B-604.5.1 and 11B-604.5.2 shall...
-
INVESTIGATION AND FINDINGS
On the basis of its investigation, the Department determined that Chicago Heights denied the Complainant appropriate auxiliary aids and services necessary for effective communication during...
