A portion of the counter surface that is 36 inches (915 mm) long minimum and 36 inches (915 mm) high maximum above the finish floor shall be provided....
Search Results "Trail Surface"
Commonly Searched Documents
-
Parallel Approach: ADA Standard Section 904.4.1
-
1011.1 General
This section contains the technical requirements for outdoor constructed features provided within camping facilities, picnic facilities, viewing areas, and trailheads or on trails....
-
F206.1 General
Exception 2 does not require accessible routes where camping facilities, picnic facilities, viewing areas, and outdoor constructed features are provided on trails....
-
11B-703.4.1 Height above finish floor or ground
Tactile characters on signs shall be located 48 inches (1219 mm) minimum above the finish floor or ground surface, measured from the baseline of the lowest Braille cells and 60 inches (1524...
-
Story
That portion of a building or facility designed for human occupancy included between the upper surface of a floor and upper surface of the floor or roof next above....
-
11B-406.5.6 Grade breaks
Grade breaks shall not be permitted on the surface of ramp runs and turning spaces. Surface slopes that meet at grade breaks shall be flush....
-
11B-303.5 Warning curbs
Abrupt changes in level exceeding 4 inches (102 mm) in a vertical dimension between walks, sidewalks or other pedestrian ways and adjacent surfaces or features shall be identified by warning...
- AJW Architectural Products U705 Series 16"W x 30"H Angle Frame Mirror w/ Mounted Shelf - Plate Glass Surface
- AJW Architectural Products U716 Series 16"W x 20"H Channel Frame Mirror w/ Mounted Shelf - Plate Glass Surface
-
STORY
[DSA-AC] That portion of a building or facility designed for human occupancy included between the upper surface of a floor and upper surface of the floor or roof next above....
-
11B-705.2 Detectable directional texture
transit boarding platforms shall comply with Figure 11B-705.2 and shall be 0.1 inch (2.5 mm) in height that tapers off to 0.04 inch (1.0 mm), with bars raised 0.2 inch (5.1 mm) from the surface...
-
Counter: ADA Standard Section 904.3.2
The counter surface height shall be 38 inches (965 mm) maximum above the finish floor or ground....
-
11B-904.3.2 Counter
The counter surface height shall be 38 inches (965 mm) maximum above the finish floor or ground....
-
1019.1 General
On outdoor recreation access routes, trails, and beach access routes, the exceptions apply only on the portion of the route where the condition applies. ...
-
1019.1 General
On outdoor recreation access routes, trails, and beach access routes, the exceptions apply only on the portion of the route where the condition applies....
-
Roll-in Access [1014.2.2]
To provide roll-in access into a camp shelter, a level or sloped entry route that complies with the technical requirements for an ORAR or trail, as applicable, must be provided along the...
-
F213.1 General
The exception exempts pit toilets provided on trails and in camping facilities....
-
CURB RAMP
[DSA-AC] A sloping prepared surface, intended for pedestrian traffic, which provides access between a walk or sidewalk and a surface located above or below an adjacent curb face....
-
Toilet Buildings and Pit Toilets
Connect pit toilets that are provided on trails to the area's other major constructed features by a route that complies with the trail specifications rather than an outdoor recreation access...
- American Specialties Single-Roll Surface Mounted Toilet Paper Holder 7305
- Bobrick TrimLine Series ADA Surface-Mounted Hand Dryer B-7120.230V
- Bobrick TrimLine Series ADA Surface-Mounted Hand Dryer B-7120.115V
- AJW Architectural Products U190 Series Singlefold Towel Dispenser - Surface Mounted
- Bobrick Surface-Mounted Multi-Roll Toilet Tissue Dispenser B-2888