The tub has a non-institutional appearance, a fold-down seat, and a swinging side entry door with a pressurized seal for ease of access....
Search Results "Patient in Side-Lying Position"
Filters
Commonly Searched Documents
-
Alternative Designs
-
What was measured and why?
., with the person sitting or lying down), the amount of energy the body is using to function (e.g., for making the heart pump, organs function) can be determined....
-
The Brewer Company, LLC
The proposed rule recommended that the height of the transfer surface during patient transfer shall be 17 inches minimum and 19 inches maximum measured from the floor to the top of the transfer...
-
§382.143(a)(3)
(3) For crewmembers subject to training requirements under 14 CFR Part 121 or 135 whose employment in any given position commences after May 13, 2009, before they assume their duties; and...
-
F206.2.8.2 Wheelchair Spaces, Ride Seats Designed for Transfer, and Transfer Devices
When amusement rides are in the load and unload position, wheelchair spaces complying with 1002.4, amusement ride seats designed for transfer complying with 1002.5, and transfer devices...
-
206.2.9.2 Wheelchair Spaces, Ride Seats Designed for Transfer, and Transfer Devices
When amusement rides are in the load and unload position, wheelchair spaces complying with 1002.4, amusement ride seats designed for transfer complying with 1002.5, and transfer devices...
-
4.16.3* Height
Seats shall not be sprung to return to a lifted position....
-
4.16.3* HEIGHT
Seats shall not be sprung to return to a lifted position....
-
1.2.2
1.2.2 Use datum dimensioning referenced to a primary or secondary control point on the construction site when the position of one item is particularly important....
-
M18
Is the flush valve located on the side adjacent to the lavatory? [ADA Standards § 4.16.5] Yes No...
-
4.7.3 Width
The minimum width of a curb ramp shall be 36 in (915 mm), exclusive of flared sides....
-
4.7.3 WIDTH
The minimum width of a curb ramp shall be 36 in (915 mm), exclusive of flared sides....
-
18. Q: May a police department create a light duty job category reserved only for incumbent officers without offering identical positions to job applicants?
A: Yes. A police department may create a specific class of light duty jobs that are limited to incumbent police officers.
-
35. Must an employer withhold discipline or termination of an employee who, because of a disability, violated a conduct rule that is job-related for the position in question and consistent with business necessity?
No. An employer never has to excuse a violation of a uniformly applied conduct rule that is job-related and consistent with business necessity. This means, for example, that an...
-
Allegion Falcon 1790 Series Exit Devices
hold back (HB) available (field selectable) Sizes: 30", 36", 42", and 48" Doors: 1 3/4" thick metal or wood, specify if wood door Projections: 3 3/8" in neutral position...
-
11 [§ 4.7.6]
Built-up curb ramps should have flared sides with a slope of 10 percent or less or have edge protection and handrails on the sides....
-
1. Location
Curb ramps must be placed to enable a person with a mobility disability to travel from a sidewalk on one side of the street, over or through any curbs or traffic islands, to the sidewalk...
-
406.4 Landings
The landing clear width shall be at least as wide as the curb ramp, excluding flared sides, leading to the landing....
-
Location of Controls
In transfer compartments, controls, faucets, and shower spray units were to be located no more than 15 inches on either side of the seat centerline, according to the proposed rule (608.5.1...
-
H1
[ADA Standards § 4.30.6] Yes No If No, install a sign with raised characters and Braille on the wall adjacent to the latch side of the door and centered 60 inches above the...
-
7b.
[ADA Stds 4.13.9] Yes _____ No _____ A clear floor space on the latch side of the door (pull side) allows a person using a wheelchair or scooter to pull the door open and then...
-
4.30.6 Mounting Location and Height
Where permanent identification is provided for rooms and spaces, signs shall be installed on the wall adjacent to the latch side of the door....
-
10.3.1(5)
Signs shall be placed at frequent intervals and shall be clearly visible from within the vehicle on both sides when not obstructed by another train....
-
11B-410.6 Doors and gates
Side doors and gates shall provide a clear width 42 inches (1067 mm) minimum....
