Section 607.5 covers the current ADA Standards bathtub controls.
Search Results "Clear Width at Turn"
Filters
Commonly Searched Documents
-
Controls: ADA Standard Section 607.5
-
IDEA Center
Analysis of individual participants with very large measurements for length identified two clear “outliers” who were excluded from the sample....
-
11B-504.4.1 Contrasting stripe
Interior stairs shall have the upper approach and lower tread marked by a stripe providing clear visual contrast....
-
Handi-Ramp Concrete Deck Ramps
These wheelchair or scooter ramps are custom designed to meet your specific needs although standard width is 48 inches, with an almost unlimited number of custom widths available, length...
-
11B-307.4.1 Guy braces
Where a guy support is used within either the width of a circulation path or 24 inches maximum outside of a circulation path, a vertical guy brace, sidewalk guy or similar device shall be...
-
11B-1008.2.3 Water play components
Where the surface of the accessible route, clear floor or ground spaces, or turning spaces serving water play components is submerged, compliance with Sections 11B-302 _|Floor or Ground...
-
11B-1008.2.3 Water play components
Where the surface of the accessible route, clear floor or ground spaces, or turning spaces serving water play components is submerged, compliance with Sections 11B-302 _|Floor or Ground...
-
11B-607.5 Controls
Controls shall be between the bathtub rim and grab bar, and between the open side of the bathtub and the centerline of the width of the bathtub....
-
Companion Seats: ADA Standard Section 1002.4.7
Where the interior width of the amusement ride is greater than 53 inches (1345 mm), seating is provided for more than one rider, and the wheelchair is not required to be centered within...
-
11B-1002.4.7 Companion seats
Where the interior width of the amusement ride is greater than 53 inches (1346 mm), seating is provided for more than one rider, and the wheelchair is not required to be centered within...
-
Wolf Cooktop Downdraft
When not in use, it lowers to provide clear sight lines in your kitchen....
-
Accessible Routes
Technical provisions address the width, slope, and surface of both ground level and elevated accessible routes....
-
Changes in Level at Entry to Wheelchair Spaces (M303.3)
The clear width of ramp runs would be required to be 36 inches minimum....
-
11B-705.2 Detectable directional texture
The width of the directional texture shall be equal to the width of the transit vehicle’s door opening. The depth of the texture shall not be less than 36 inches (914 mm)....
-
Boat Slips
According to the table, one slip must be accessible, with clear pier space at least 40 feet long and a minimum width of 60 inches....
-
FOREWORD
Some examples of findings include: Sweep Width-The 85th percentile inline skater had a 1.5-meter (m) (4.9-foot (ft) sweep width, wider than the AASHTO recommended width for bike lanes...
-
GE® 24" Standard Clean Free-Standing Gas Range JGAS02SENSS
Burner - Right Front 9,100 BTU Burner - Right Rear 9,100 BTU Cooktop Burner Grate Material 2 Doubles Heavy Cast Valves (Degree of Turn...
-
Lateral grab bar use
Table 12 summarizes the average clear space required for our subjects to position their WMD to perform a transfer in each protocol in terms of width, depth, and angle of approach (Figure...
-
Circulation Paths
Objects that overhang circulation paths do not provide clear headroom....
-
Handrail Extensions: ADA Standard Section 505.10
Section 505.10 covers the current ADA Standards for handrail extensions.
-
DORMA ED100/250 Swing Door Operator
A clear commitment to the environment The ED100/ED250 operators reflect DORMA’s commitment to the environment in both manufacture and performance....
-
Ground Surfaces
Section 1008.2.6 of the 2010 Standards provides technical requirements for accessible ground surfaces for play areas on accessible routes, clear floor or ground spaces, and turning spaces...
-
Accessibility - Flatness and Lippage
Project specifications should make clear which trade is responsible for the required alterations if the subfloor is found not to be in compliance with the flatness requirements....
-
Landings [4.8.4]
This applies to switchback ramps, ramps with a 90 degree turn, and angled ramps. Recommendation: Ramps and landings should be configured to facilitate maneuvering....
