Openings in the surface of trails, passing spaces, and resting intervals shall not allow the passage of a sphere more than 1/2 inch (13 mm) in diameter. Advisory 1017.6 Openings. ...
Search Results "Wheelchair Space"
Commonly Searched Documents
-
1017.6 Openings
-
1017.6 Openings
Openings in the surface of trails, passing spaces, and resting intervals shall not allow the passage of a sphere more than 1/2 inch (13 mm) in diameter. Advisory 1017.6 Openings....
-
I fully support ADA requirements and the DGS' efforts. We are reconstructing a 325 space parking lot. 8% will be EVSE ready. 32 EVSE will be installed initially. Including EVSE required ADA spaces, new plan results in 322 spaces. Parking facility no longer complies with minimum parking requirements for facilities. Any suggestions for resolving this conflict for reworking of existing sites subject to CALGreen?
RESPONSE: Parking ordinances are typically adopted within each city and county in California and enforced by local planning department personnel. You could consider requesting a...
-
4.1.6(1)(d)
(d) No alteration of an existing element, space, or area of a building shall impose a requirement for greater accessibility than that which would be required for new construction....
-
M6
Inside the room is there an area for a person who uses a wheelchair to turn around - either a 60-inch diameter circle or a “T”-shaped turn area?...
-
Tips for Communicating with Individuals with Mobility Impairments
If possible, put yourself at the wheelchair user's eye level. Do not lean on a wheelchair or any other assistive device....
-
Forward Reach [4.2.5]
Many people in wheelchairs may not be able to reach far beyond their toes. Forward reaches are measured to the edge of available clear floor space....
-
M101.2 Application (Section-by-Section Analysis)
Additionally, the final rule also exempts weight scales which contain a wheelchair space complying with M303 and that have a seat integral to the equipment from complying with M302 (M302.1...
-
FIELD DATA COLLECTION PLAN
Space required for three-point turn. Lateral operating space (sweep width). Turning radii. Acceleration capabilities. Speed....
-
4.7.5 Openings
Openings in surface of the clear floor or ground spaces required by section 2.0 shall not allow passage of a sphere more than 1/2 inch (13 mm) in diameter....
-
R309.2.2 Narrow Sidewalks
When an access aisle is not provided, the parking spaces shall be located at the end of the block face. Advisory R309.2.2 Narrow Sidewalks....
-
11B-604.8.1.2 Doors
Doors shall not swing into the clear floor space or clearance required for any fixture....
-
11B-604 Water closets and toilet compartments
around the water closet shall be permitted to overlap the water closet, associated grab bars, dispensers, sanitary napkin disposal units, coat hooks, shelves, accessible routes, clear floor space...
-
11B-812.6.4 Drive-up
Vehicle spaces serving drive-up EVCS shall be 204 inches (5182 mm) wide minimum and shall not be required to have an adjacent access aisle....
-
5.3.2.2 Surface
The surface of the turning space and clear floor or ground space shall be firm and stable....
-
1012.4 Surface
This section requires the surface of parking spaces and pull-up spaces to be firm and stable....
-
Sinks [4.24]
Where multiple sinks are provided in a space (e.g., laboratory classrooms), access to at least one or 5% in each such space is generally sufficient....
-
604.3 Clearance
Clearances around water closets and in toilet compartments shall comply with 604.3.
-
604.3.1 Size
Clearance around a water closet shall be 60 inches (1525 mm) minimum measured perpendicular from the side wall and 56 inches (1420 mm) minimum measured perpendicular from the rear...
-
F202.6 Leases
Buildings or facilities for which new leases are negotiated by the Federal government after the effective date of the revised standards issued pursuant to the Architectural Barriers...
-
604.3 Clearance
Clearances around water closets and in toilet compartments shall comply with 604.3.
-
604.3.1 Size
Clearance around a water closet shall be 60 inches (1525 mm) minimum measured perpendicular from the side wall and 56 inches (1420 mm) minimum measured perpendicular from the rear...
-
604.3.1 Size
604.3.1 Size. Clearance around a water closet shall be 60 inches (1525 mm) minimum measured perpendicular from the side wall and 56 inches (1420 mm) minimum measured perpendicular...
-
604.3 Clearance
604.3 Clearance. Clearances around water closets and in toilet compartments shall comply with 604.3.