[See subsections ...]
Search Results "Parking Surface"
-
Figure M1: Overview of M301 Diagnostic Equipment for Use by a Patient in a Supine, Prone, or Side-Lying Position
-
5.3.2.1 Transfer Sides Recommendation for Stretchers
5.3.2.1 Transfer Sides Recommendation for Stretchers On stretchers, the transfer surface is oriented along the long dimension of the surface on which patients are in the supine, prone...
-
Other Counters/ Teller Windows [7.2(2)]
Windows [7.2(2)] Alternatives to 36-inch high counters (lowered portions, folding shelves) are recognized since other design considerations (security, use by standees) may make a higher surface...
-
Cross Slope
Cross Slope The cross slopes of gangways, transition plates and floating piers that are part of an accessible route must be designed and constructed to not exceed a maximum of 2...
-
5.3.3 Transfer Sides for Equipment Used by Patients in Seated Position
5.3.3 Transfer Sides for Equipment Used by Patients in Seated Position.
-
5.3.3.1 Transfer Sides for Exam Chairs with Fixed Footrests
5.3.3.1 Transfer Sides for Exam Chairs with Fixed Footrests. The 17 inch minimum depth and 21 inch minimum width should be located on both sides of examination chairs with a fixed...
-
Addendum E: Comparison of participants tested at the National Disabled Veterans Winter Sports Clinic (NDVWSC) compared to the participants tested at the Human Engineering Research Laboratories and Hiram G. Andrews Center
At the time this addendum was composed, there were 31 participants enrolled in the phase 2 study at HERL (27 men and 4 women). This group of subjects was compared to all the...
-
Kitchen Cabinets
42” a.f.f. (above finished floor) wall-mounted cabinets and counters for tall people. With a remodel, they can be lowered to 32” a.f.f. for wheelchair users 10”...
-
9.2* POST OFFICE LOBBIES
Where writing desks or tables are provided, a minimum of at least one writing desk or table that complies with 4.32 must be provided. Clear passageways in front of customer service...
-
Circular Cross Section and Clearance (§505.5, §505.7)
Circular Cross Section and Clearance (§505.5, §505.7)
-
5.3.2.1 Transfer Sides for Stretchers
The transfer surface shall be located to provide the ability to transfer from a mobility device onto both long sides of the surface....
-
Accessible Path of Travel
The accessible path of travel must extend from the altered primary function area to site arrival points, including public sidewalks and parking and passenger loading zones provided on the...
-
Amos Winter: The cheap all-terrain wheelchair | TED Talks
How do you build a wheelchair ready to blaze through mud and sand, all for under $200? MIT engineer Amos Winter guides us through the mechanics of an all-terrain wheelchair that's...
-
Where to Measure Along the Route
-
11B-226.4 Baby changing tables
If they must be modified, for example, to comply with the maximum work surface height of 34 inches, their noncompliant location (i.e., inside an accessible water closet compartment, or obstructing...
-
M305.2.1.1 End Transfer Supports
Transfer supports for transfer surfaces complying with M301.2.3.1 and M302.2 shall be located on the short side (length) opposite the transfer side....
-
M301.2.2 Sunset Provision (Section-by-Section Analysis)
(Significant Changes – Transfer Surface Adjustability), this is a new provision that was added to the final rule in conjunction with the new requirement of a low height range in M301.2.1...
-
406.2.3 Accessible parking spaces
Where parking is provided, accessible parking spaces, access aisles and vehicular routes serving accessible parking shall be provided in accordance with Chapter 11A or Chapter 11B, as applicable...
-
Is My Ramp ADA Compliant?
-
11B-250 Circulation paths
[See subsections ...]
-
3.5.1 General
Per section F216 of the ABAAS, the ISA shall be posted at the following six locations: Accessible parking spaces in parking lots where there are 5 or more designated parking spaces...
-
M301.2.3 Transfer Sides
(width) of the surface...
-
5.4.7 Transfer Support Gripping Surface Clearance Recommendation for M301 and M302
5.4.7 Transfer Support Gripping Surface Clearance Recommendation for M301 and M302 Description: A clearance around the gripping surface is necessary to ensure sufficient space for a person...
