Video demonstration of how the Norton Surface Mounted 5600 Hands-Free Door Operation Kit works using a rest room door as an example. ...
Search Results "Ground Surface"
Commonly Searched Documents
- Norton Surface Mounted 5600 Hands-Free Door Operation Kits
-
704.7 Unexposed surface temperature
Where protected openings are not limited by Section 704.8, the limitation on the rise of temperature on the unexposed surface of exterior walls the exterior wall in any story, the total...
-
5.3.2 Transfer Sides for Equipment Used by Patients in a Supine, Prone, or Side-Lying Position
5.3.2 Transfer Sides for Equipment Used by Patients in a Supine, Prone, or Side-Lying Position.
-
Bathroom Accommodating Reduced Ambulatory Mobility
Ceiling lift between the bathtub and toilet (this is actually fun to use) – reinforcement less than $50 Chromatherapy bathtub for relaxation FSC certified maple...
-
M301.3.1 Transfer Supports
Transfer supports shall be provided for use with the transfer sides required by M301.2.3 and shall comply with M305.2.
-
1133A.1 General
Kitchens shall be on an accessible route and shall comply with this section. (See Figure 11A-10A.)
-
11B-1008.2.4.1 Ground level
At ground level, the clear width of accessible routes shall be 60 inches (1524 mm) minimum. Exceptions: 1. ...
-
11B-1008.2.4.1 Ground level
At ground level, the clear width of accessible routes shall be 60 inches (1524 mm) minimum. Exceptions: 1....
-
11B-1008.2.4.1 Ground level
At ground level, the clear width of accessible routes shall be 60 inches (1524 mm) minimum....
-
R208 Detectable Warning Surfaces
R208 Detectable Warning Surfaces...
-
R305 Detectable Warning Surfaces
R305 Detectable Warning Surfaces...
-
Cross Section of Gripping Surfaces
The Access Board is considering whether the above cross section dimensions would be appropriate for the gripping surfaces of transfer supports on diagnostic equipment used by patients in...
-
5.8.2.2 Knee Clearance Depth at 27” Above the Ground
5.8.2.2 Knee Clearance Depth at 27” Above the Ground. The knee clearance should be increased at 27 inches above the ground to 18 inches minimum....
-
5.8.2.2 Knee Clearance Depth at 27” Above the Ground
5.8.2.2 Knee Clearance Depth at 27” Above the Ground The Committee recommends increasing the knee clearance at 27 inches above the ground to 18 inches minimum....
-
Ground Level Requirements Based on Elevated Play Components
Ground Level Requirements Based on Elevated Play Components The number and variety of ground-level play components required to be on an accessible route is also determined by the number...
-
4.29.2* Detectable Warnings on Walking Surfaces
4.29.2* Detectable Warnings on Walking Surfaces....
-
§ 38.23(b)(6) Platform surface
(6) Platform surface. The platform surface shall be free of any protrusions over 1/4 inch high and shall be slip resistant....
- Federal Trail Data Standards (FTDS)
-
11B-224.7 Housing at a place of education
Housing at a place of education subject to this section shall comply with Sections 11B-224.1 through 11B-224.6 and 11B-806 for transient lodging guest rooms. For the purposes of the...
-
11B-224.7 Housing at a place of education
Housing at a place of education subject to this section shall comply with Sections 11B-224.1 through 11B-224.6 and 11B-806 for transient lodging guest rooms. For the purposes of the...
-
Which surfaces are accessible to everyone?
Which surfaces are accessible to everyone? There are no surfaces that are accessible to everyone, because there is an infinite range of abilities among the population....
-
11B-903.2 Clear floor or ground space
Clear floor or ground space complying with Section 11B-305 shall be provided and shall be positioned at the end of the bench seat and parallel to the short axis of the bench....
-
11B-903.2 Clear floor or ground space
Clear floor or ground space complying with Section 11B-305 shall be provided and shall be positioned at the end of the bench seat and parallel to the short axis of the bench....
-
11B-903.2 Clear floor or ground space
Clear floor or ground space complying with Section 11B-305 shall be provided and shall be positioned at the end of the bench seat and parallel to the short axis of the bench....