Section 4.1.3(19)(a) of the 1991 Standards requires one percent (1%) of fixed seats in assembly areas to be designated aisle seats with either no armrests or folding or retractable armrests...
Search Results "Referenced Standard"
Filters
Commonly Searched Documents
-
Designated Aisle Seats
-
Issue 14: How can improved lighting and zero net energy goals by achieved while improving health care?
We have some of our standards relative to lighting that we think are appropriate for whatever function that we’re doing; it’s different needs for different functions....
-
T403 Lifts
These commenters urged the Access Board to instead reference existing standards for public vehicular lifts set forth in the FMVSS, which are issued by the National Highway Traffic Safety...
-
Literature Cited
Standard specification for impact attenuation of surface systems under and around playground equipment, ASTM F1292....
-
Conclusion
Where the playground surface material fails to comply with safety standards for impact attenuation, children are put at risk of injury. ...
-
15(b)
(b) In determining whether any Post-1993 Owned Hotel and Post-1993 Joint Venture Hotel has complied with the ADA Standards, the Parties agree that each Post-1993 Owned Hotel and each Post...
-
BlueDAG App
Identify barriers faster: Use the BlueDAG Barrier Finder and Check List tools to identify barriers based on applicable federal and state standards....
-
g) New Construction and Alterations
contends that "the City's policies and procedures regarding new construction and alterations . . . do not require a close-out inspection for compliance with federal disability access design standards...
-
Height – M301.2.1 & M302.2.1
Height – M301.2.1 & M302.2.1 The subcommittee discussed the increments for adjustability and decided that infinite adjustability is the appropriate standard as both electronic and...
-
If the manufacturer states that the design load is 800 pounds, can the transportation operator limit actual use to 600 pounds for safety reasons?
The NHTSA safety standards and the DOT ADA regulations were designed to complement each other....
-
Paperwork Reduction Act
Under this rule, railroads that choose to use a means of meeting the performance standard other than level-entry boarding would have to submit a proposed plan to FRA or FTA demonstrating...
-
Area of Refuge Identification [IBC §1007.6.5 (2003), §1003.2.13.5.5 (2000)]
Both the IBC and the ADA Standards apply requirements for tactile and visual characters to the area of refuge signs....
-
§ 37.9(b)
not consistent with the requirements set forth in Appendices B and D to 36 CFR part 1191 and Appendix A to this part, if the modifications complied with the Uniform Federal Accessibility Standards...
-
§382.57(c)
(c) You must ensure that the automated airport kiosks provided in accordance with this section conform to the following technical accessibility standards with respect to their physical design...
-
1132A.3, Item 4
A nominal 32-inch (813 mm) clear opening provided by a standard 6-foot wide (1829 mm) sliding patio door assembly is acceptable....
-
D. Unfunded Mandates Reform Act
The proposed standards do not impose any mandatory requirements on state, local, or tribal governments or the private sector....
-
Midmark Corporation
Midmark Corporation RECOMMENDATION OF ALIGNING TRANSFER SUPPORT WEIGHT REQUIREMENTS WITH BIFMA STANDARDS SEPTEMBER 27, 2013 SUBMITTED BY: Midmark Corporation (Bob Menke, committee...
-
§ 36.304(d)(4)(iii)
(iii) Where an existing sauna or steam room was designed and constructed to seat only two people, it shall be exempt from the provisions of section 241 of the proposed standards....
-
11B-705.1.1.2 Dome size
11B-705.1.1.2 Dome size Aligns California Building Code dimensional requirements for detectable warning dome heights with federal ADA Standards...
-
§ 382.57(c)
(c) You must ensure that the automated airport kiosks provided in accordance with this section conform to the following technical accessibility standards with respect to their physical design...
-
702.2.1 ATSC A/53 Part 5
2014, Digital Television Standard, Part 5—AC-3 Audio System Characteristics, August 28, 2014, IBR approved for Appendix C, Section 414.1.1....
-
A6
If a curb ramp is provided, is the running slope of the ramp surface (not counting the side flares) no more than 1:12 or 8.33% [ADA Standards § 4.7.2] Yes No...
-
H17
[ADA Standards § 4.17.4] Yes No...
-
§104.33(b)(2)
(2) Implementation of an Individualized Education Program developed in accordance with the Education of the Handicapped Act is one means of meeting the standard established in paragraph ...
