For the visually impaired and others using screen readers the website should meet WCAG 2.0 minimum standards....
Search Results "Minimum Dimension"
-
Website Access
-
12186(d)(2) Vehicles and rail passenger cars
or rail passenger car be readily accessible to and usable by individuals with disabilities, if the design for such vehicle or car complies with the laws and regulations (including the Minimum...
-
11B-602.9 Pedestrian protection
The protected area within which a drinking fountain is located shall be 32 inches (813 mm) wide minimum and 18 inches (457 mm) deep minimum, and shall comply with Section 11B-305.7....
-
12165(b) Rail passenger cars
this title that a rail passenger car be readily accessible to and usable by individuals with disabilities, if the design for such car complies with the laws and regulations (including the Minimum...
-
609.4 Position of Grab Bars
Grab bars shall be installed in a horizontal position, 33 inches (840 mm) minimum and 36 inches (915 mm) maximum above the finish floor measured to the top of the gripping surface, except...
-
1011.7 Outdoor Rinsing Showers
Outdoor rinsing showers shall provide at least one hand-held shower spray unit with a hose 59 inches (1500 mm) long minimum....
-
Error/Omission: Food service queuing areas are too narrow and do not provide adequate clear width for turns.
The minimum clear width of an accessible route shall be 36 in (915 mm) except at doors (see 4.13.5 and 4.13.6)....
-
11B-604.9.1 Location
The centerline of the water closet shall be 12 inches (305 mm) minimum and 18 inches (457 mm) maximum from the side wall or partition, except that the water closet shall be 17 inches (432...
-
§ 38.39(b)
(b) Characters on signs required by paragraph (a) of this section shall have a width-to-height ratio between 3:5 and 1:1 and a stroke width-to-height ratio between 1:5 and 1:10, with a minimum...
-
11B-602.9 Pedestrian protection
The protected area within which a drinking fountain is located shall be 32 inches (813 mm) wide minimum and 18 inches (457 mm) deep minimum, and shall comply with Section 11B-305.7....
-
11B-802.1.2 Width
A single wheelchair space shall be 36 inches (914 mm) wide minimum. ...
-
904.4.1 Parallel Approach
A portion of the counter surface that is 36 inches (915 mm) long minimum and 36 inches (915 mm) high maximum above the finish floor shall be provided....
-
1009.3.2 Submerged Depth
Sloped entries shall extend to a depth of 24 inches (610 mm) minimum and 30 inches (760 mm) maximum below the stationary water level....
-
609.4 Position of Grab Bars
Grab bars shall be installed in a horizontal position, 33 inches (840 mm) minimum and 36 inches (915 mm) maximum above the finish floor measured to the top of the gripping surface, except...
-
Inclusion Solutions Voting Booth Accessories Franklin Voting Chair
Compatible with all accessible voting systems and voting booths. 23.25” chair width is optimal dimension to fit under 32” required minimal ADA clearance space under voting booths...
-
World Dryer Nova 1® Hand Dryer
great value Thermally-protected motor, tamper resistant screws Low sound level Suitable for light traffic and quiet facilities Operation: Automatic Dimension...
-
TrueForm 30" ADA Floating Concrete Sink FLO-30-ADA
Description 30" ADA Floating Concrete Sink Concrete Sink meets ADA Accessibility Guidelines Dimensions: 30"L x 21"W x 5"H Create a clean contemporary look for your residential...
-
Behavioral Safety Products #TC230 Suicide Resistant Standard Trap Cover
It can be ordered pre-cut or can be cut on site to fit the dimensions of the existing sink. It is fastened, with security fasteners, to blocking within the wall....
-
Delta Two Handle Widespread Lavatory Metal Pop-Up 3594-MPU-DST
matching finish drain assembly Meets standards set by Americans with Disabilities Act (ADA) 1.50 gpm @ 60 psi, 5.7 L/min @ 414 kPa 3-hole 4-16 in. installation Rigid spout Assembled dimensions...
-
11B-706.5 Signal-to-noise ratio
The signal-to-noise ratio for internally generated noise in assistive listening systems shall be 18 dB minimum....
-
5.4.2.1 Transfer Support Length for Stretchers
Transfer supports on stretchers should be a minimum of 15 inches long....
-
1133A.4, Item 2
A minimum linear length of 30 inches (762 mm) of countertop shall be provided for a work surface....
-
4.33.2* Size of Wheelchair Locations
Each wheelchair location shall provide minimum clear ground or floor spaces as shown in Fig. 46....
