(b) Characters on signs required by paragraph (a) of this section shall have a width-to-height ratio between 3:5 and 1:1 and a stroke width-to-height ratio between 1:5 and 1:10, with a minimum...
Search Results "Enhanced 9-1-1"
-
§ 38.55(b)
-
Alterations/ Historic Preservation
Steeper slopes are allowed for short ramps where a 1:12 slope is not technically feasible....
-
§ 38.23(c)(3) Ramp threshold
The transition from roadway or sidewalk and the transition from vehicle floor to the ramp may be vertical without edge treatment up to 1/4 inch....
-
4.1.6(3)(a)(ii)
(ii) A slope between 1:8 and 1:10 is allowed for a maximum rise of 3 inches. A slope steeper than 1:8 is not allowed....
-
4.1.6(4)(a)
Curb ramps and ramps to be constructed on existing sites or in existing buildings or facilities may have slopes and rises as shown in Table 2 if space limitations prohibit the use of a 1:...
-
11B-303.3 Beveled
A change in level of 1/2 inch (13 mm) is permitted to be 1/4 inch (6.4 mm) vertical plus 1/4 inch (6.4 mm) beveled....
-
5.8.2 Knee and Toe Clearance Recommendations under Breast Platform Recommendations
Toe clearance shall be provided at a height of 9 inches above the floor to a depth of 6 inches maximum. M303.2.4.2 Knee Clearance....
-
11B-233.3.1.2.6.2 Test number one, individual building test
It is not required by this code to provide an accessible route when the terrain of the site is such that both of the following apply: 1....
-
11B-233.3.1.2.6.2 Test number one, individual building test
It is not required by this code to provide an accessible route when the terrain of the site is such that both of the following apply: 1....
- Willoughby Industries HS-1013-46-HC 18" wide Lavatory
-
APPENDIX RESOURCES FOR LOCATING REASONABLE ACCOMMODATIONS
Equal Employment Opportunity Commission 1-800-669-3362 (Voice) 1-800-800-3302 (TT) The EEOC's Publication Center has many free documents on the Title I employment provisions of the...
-
11B-228.3.2.1 Public use or common use EVCS
to 4 1 0 0 5 to 25 1 1 0 26 to 50 1 1 1 51 to 75...
- Sears Brands, LLC Craftsman 10 in. Digital LaserTrac® Level
-
11B-227.2 Check-out aisles
NUMBER OF CHECK-OUT AISLES OF EACH FUNCTION MINIMUM NUMBER OF CHECK-OUT AISLES OF EACH FUNCTION REQUIRED TO COMPLY WITH 11B-904.3 1...
-
11B-227.2 Check-out aisles
NUMBER OF CHECK-OUT AISLES OF EACH FUNCTION MINIMUM NUMBER OF CHECK-OUT AISLES OF EACH FUNCTION REQUIRED TO COMPLY WITH 11B-904.3 1...
-
Maneuvering Clearances [§404.2.4]
Such doors are usually wider to accommodate beds and gurneys, and they are often located close to adjacent interior walls to facilitate circulation and to enhance privacy. ...
-
Areas of Refuge: ADA Standard Section 216.4.2
Section 216.4.2 covers scoping requirements in the current ADA Standards for signs at areas of refuge.
-
Handrails: ADA Standard Section 403.6
Section 403.5.4 covers the current ADA Standards for handrails that are provided along walking surfaces of accessible routes.
-
Handrails: ADA Standard Section 1008.2.5.3
EXCEPTIONS: 1. Handrails shall not be required on ramps located within ground level use zones. 2. Handrail extensions shall not be required....
-
Seat Location: ADA Standard Section 1009.2.2
The deck surface between the centerline of the seat and the pool edge shall have a slope not steeper than 1:48....
-
11B-1009.2.2 Seat location
The deck surface between the centerline of the seat and the pool edge shall have a slope not steeper than 1:48....
-
11B-1009.2.2 Seat location
The deck surface between the centerline of the seat and the pool edge shall have a slope not steeper than 1:48....
-
1607A.9.2 Grab bars, shower seats and accessible benches
[DSA-AC & HCD 1-AC] See Chapter 11A, Section 1127A.4, and Chapter 11B, Sections 11B-609.8, 11B-610.4 and 11B-903.6, for grab bars, shower seats and dressing room bench seats, as applicable...
-
1607.9.2 Grab bars, shower seats and accessible benches
[DSA-AC & HCD 1-AC] See Chapter 11A, Section 1127A.4, and Chapter 11B, Sections 11B-609.8, 11B-610.4 and 11B-903.6, for grab bars, shower seats and dressing room bench seats, as applicable...