(b) Characters on signs required by paragraph (a) shall have a width-to-height ratio between 3:5 and 1:1 and a stroke width-to-height ratio between 1:5 and 1:10, with a minimum character...
Search Results "Enhanced 9-1-1"
-
§ 38.105(b)
-
§ 38.95(b)(8) Platform entrance ramp
The entrance ramp, or loading-edge barrier used as a ramp, shall not exceed a slope of 1:8, when measured on level ground, for a maximum rise of 3 inches, and the transition from station...
-
Operable Parts: ADA Standard Section 804.6.2
EXCEPTIONS: 1. Appliance doors and door latching devices shall not be required to comply with 309.4. 2....
-
11B-608.9 Shower floor or ground surface
Floor or ground surfaces of showers shall comply with Section 11B-302.1 and shall be sloped 1:48 maximum in any direction....
-
11B-809.10.6.2 Slope
The slope of the shower floor shall be 1/2 inch (12.7 mm) per foot maximum in any direction and shall slope to a drain....
-
11B-812.3 Floor or ground surfaces
Changes in level, slopes exceeding 1:48, and detectable warnings shall not be permitted....
-
3104.2 Separate structures
Exceptions: … [DSA-AC and HCD 1-AC] For purposes of accessibility in residential facilities as required by Chapters 11A and 11B, structurally connected buildings, buildings...
-
11B-608.9 Shower floor or ground surface
Floor or ground surfaces of showers shall comply with Section 11B-302.1 and shall be sloped 1:48 maximum in any direction....
-
11B-809.10.6.2 Slope
The slope of the shower floor shall be 1/2 inch (12.7 mm) per foot maximum in any direction and shall slope to a drain....
-
11B-812.3 Floor or ground surfaces
Changes in level, slopes exceeding 1:48, and detectable warnings shall not be permitted....
-
Legislation
1/2" high....
-
602.3 Electronic Support Documentation
including Web-based self-service support, shall conform to all Level A and Level AA Success Criteria and all Conformance Requirements in WCAG 2.0 (incorporated by reference in Chapter 1)...
-
405.2 Slope
Ramp runs shall have a running slope not steeper than 1:12....
-
405.2 Slope
Ramp runs shall have a running slope not steeper than 1:12....
-
405.2 Slope
Ramp runs shall have a running slope not steeper than 1:12....
-
General: ADA Standard Section 306.3.1
Section 306.3.1 of the ADA Standards covers information in the current ADA Standards for knee clearance.
-
1.1.9 Horizontal gaps and vertical alignment
Measuring devices should be capable of measuring to a precision of 1/16 in. (1 mm)....
-
§ 38.75(c)
(c) Characters on signs required by paragraphs (a) or (b) of this section shall have a width-to-height ratio between 3:5 and 1:1 and a stroke width-to-height ratio between 1:5 and 1:10,...
-
§ 38.27(c)
(c) Characters on signs required by paragraphs (a) and (b) of this section shall have a width-to-height ratio between 3:5 and 1:1 and a stroke width-to-height ratio between 1:5 and 1:10,...
-
§ 38.55(b)
(b) Characters on signs required by paragraph (a) of this section shall have a width-to-height ratio between 3:5 and 1:1 and a stroke width-to-height ratio between 1:5 and 1:10, with a minimum...
-
Alterations/ Historic Preservation
Steeper slopes are allowed for short ramps where a 1:12 slope is not technically feasible....
-
§ 38.23(c)(3) Ramp threshold
The transition from roadway or sidewalk and the transition from vehicle floor to the ramp may be vertical without edge treatment up to 1/4 inch....
-
4.1.6(3)(a)(ii)
(ii) A slope between 1:8 and 1:10 is allowed for a maximum rise of 3 inches. A slope steeper than 1:8 is not allowed....
-
4.1.6(4)(a)
Curb ramps and ramps to be constructed on existing sites or in existing buildings or facilities may have slopes and rises as shown in Table 2 if space limitations prohibit the use of a 1:...