Ramp runs shall have a running slope not steeper than 1:12....
Search Results "Ramp Surface"
Filters
Commonly Searched Documents
-
M303.3.3.1 Running Slope
-
Slope: ADA Standard Section 810.2.4
Parallel to the roadway, the slope of the bus stop boarding and alighting area shall be the same as the roadway, to the maximum extent practicable. Perpendicular to the roadway, the...
-
11B-810.2.4 Slope
Parallel to the roadway, the slope of the bus stop boarding and alighting area shall be the same as the roadway, to the maximum extent practicable. Perpendicular to the roadway, the...
-
5.2.1 Transfer Surface Size Recommendations for M301
5.2.1 Transfer Surface Size Recommendations for M301 Description: The transfer surface is the part of the diagnostic equipment onto which patients who use mobility devices or aids transfer...
-
DSA IR 11B-3: DETECTABLE WARNINGS AT CURB RAMPS (with revisions issued through Jan. 2011)
General: California Building Code Sections 1127B.5 Item 8 and 1117A.4.7 state “a curb ramp shall have a detectable warning….when the ramp slope is less than 1 unit vertical to 15 units horizontal...
-
C. Boarding and Deplaning Assistance
[Sec. 382.39(a)] The type of assistance you must offer includes, as needed, services personnel and the use of wheelchairs, ramps, or mechanical lifts....
-
5.1.3 Slope
The slope of the surface of the clear floor or ground space inside the camp shelter shall not be steeper than 1:48 (2 percent) in all directions....
-
Jeanne Halloin, IES. Existing Standards and Design Guidance
Entrances (slides 3 and 4) Additional comments: Need better signage at entrances Handle locations should be consistent Ramps (slide 5) Route of Travel...
-
4.1.7(1)(a)
(a) As a general rule, the accessibility provisions of part 4 shall be applied to "qualified" historic buildings and facilities. "Qualified" buildings or facilities are those...
-
5.2 Transfer Surface Size Recommendations
5.2 Transfer Surface Size Recommendations...
-
Employee Work Areas: ADA Standard Section 203.9
Section 203.9 covers scoping requirements of general exceptions for employee work areas in the most current ADA Standards.
-
D. Chapter 3: Building Blocks
Chapter 3 in the 2016 Non-Rail Vehicle Guidelines contains the technical requirements related to three areas—walking surfaces (T302), handrails, stanchions, and handholds (T303), and operable...
-
1008.2.6.2 Use Zones
Ground surfaces located within use zones shall comply with ASTM F 1292 (1999 edition or 2004 edition) (incorporated by reference, see "Referenced Standards" in Chapter 1)....
-
Reese Enterprises, Inc. PERFEC MATv * Aluminum Hinge
They offer solid footing and abrasive surfaces, and they are available in a variety of materials and colors to complement any entry area....
-
Background
Some engineered wood fiber (EWF) and chipped wood surfaces on playgrounds are difficult for those who use mobility aids, such as wheelchairs and walkers, because the surfaces are soft and...
-
F240.1 General
In existing play areas, where play components are relocated for the purposes of creating safe use zones and the ground surface is not altered or extended for more than one use zone, the...
-
240.1 General
In existing play areas, where play components are relocated for the purposes of creating safe use zones and the ground surface is not altered or extended for more than one use zone, the...
-
240.1 General
In existing play areas, where play components are relocated for the purposes of creating safe use zones and the ground surface is not altered or extended for more than one use zone, the...
-
seca 664 - electronic wheelchair scale_without comments - seca1840
Easy access is assured by its extremely low platform and the self-lowering ramps. The secure side rails give additional safety....
-
M305.2.6 Gripping Surface
Transfer support gripping surfaces shall be continuous along their length and shall not be obstructed along their tops or sides....
-
M301.2.1, M302.2.1 Transfer Height
measured from the floor to the top of the transfer surface...
-
Tread Obstacles on Outdoor Recreation Access Routes
A tread obstacle is anything that interrupts the evenness of the tread surface....
-
Transfer Surface Size – M301.2.2 Supine, Prone, or Side-Lying Position
Transfer Surface Size – M301.2.2 Supine, Prone, or Side-Lying Position The issues were discussed and decided in the full committee meeting as follows: depth of 17 inches minimum and width...
-
1009.8 Two-way communication
Two-way communication systems are not required on floors provided with ramps conforming to the provisions of Section 1012....
