In U-shaped kitchens enclosed on three contiguous sides, clearance between all opposing base cabinets, counter tops, appliances, or walls within kitchen work areas shall be 60 inches (1524...
Search Results "Curb Ramp Top Landing"
Commonly Searched Documents
-
11B-804.2.2 U-Shaped
-
505 Handrails
Specifications for handrails in section 505 apply to those provided at ramps, stairs, and along walking surfaces....
-
810.2.2 Dimensions
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2440 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
-
A. Entrances
Entrances: (1) Royal Street Accessible Entrance and Guest Pull-up Space – Defendants will reconstruct the curb and sidewalk to meet 2010 Standards §§ 206.2.1, 209, 402.2, 405, 406, and...
-
4(6)
(6) At the primary entry door to dwelling units with direct exterior access, outside landing surfaces constructed of impervious materials such as concrete, brick or flagstone, are no more...
-
The Outdoors Are for Everyone—Fundamentals of Outdoor Recreation and Trails Accessibility
Public lands offer a wide range of recreation settings and opportunities from highly developed campgrounds to untouched wilderness areas....
-
804.2.2 U-Shaped
In U-shaped kitchens enclosed on three contiguous sides, clearance between all opposing base cabinets, counter tops, appliances, or walls within kitchen work areas shall be 60 inches (1525...
-
Stairways [§504]
Recommendation: Providing visual contrast (light-on-dark or dark-on-light) on the top and bottom steps that is approximately 2 inches wide and located either on nosings or at the leading...
-
1135A.1 General
Where front-loading clothes washers are not provided, management shall provide assistive devices, on request of the occupant, to permit the use of top-loading clothes washers....
-
1135A.1 General
Where front-loading clothes washers are not provided, management shall provide assistive devices, on request of the occupant, to permit the use of top-loading clothes washers....
-
12207(c)(1) In general
wheelchair, and consistent with the Wilderness Act no agency is required to provide any form of special treatment or accommodation, or to construct any facilities or modify any conditions of lands...
-
Doors
DOORS 32” clear width 11B-404.2.3 Maneuvering clearances 11B-404.2.4.1 Level landings...
-
Doors
DOORS 32” clear width 11B-404.2.3 Maneuvering clearances 11B-404.2.4.1 Level landings...
-
RECOMMENDATIONS
RECOMMENDATIONS An objective test procedure for measuring the firmness and stability of surfaces with a portable device and performance specifications need to be accepted in order to enable land...
-
How to access video description
How to access video description Video description is provided through the TV or set top box "secondary audio"; feature, which some TV controls identify as "SAP"; or "secondary audio...
-
Site Constraints
Platform lifts are permitted where "existing or other constraints" make ramp or elevator access "infeasible."...
- Assisted Living Directory - Top Assisted Living Markets - Phoenix, Arizona Assisted Living Facilities & Senior Care
- Assisted Living Directory - Top Assisted Living Markets - Salinas, California Assisted Living Facilities & Senior Care
- Assisted Living Directory - Top Assisted Living Markets - Detroit, Michigan Assisted Living: Featured Facilities & Services
- Assisted Living Directory - Top Assisted Living Markets - Tampa, Florida Assisted Living Facilities & Senior Care
- Assisted Living Directory - Top Assisted Living Markets - Pittsburgh, Pennsylvania Assisted Living Facilities & Senior Care
- Assisted Living Directory - Top Assisted Living Markets - Chicago, Illinois Assisted Living Facilities & Senior Care
-
705.1.1 Dome Size
Truncated domes in a detectable warning surface shall have a base diameter of 0.9 inch (23 mm) minimum and 1.4 inches (36 mm) maximum, a top diameter of 50 percent of the base diameter minimum...
-
705.1.1 Dome Size
Truncated domes in a detectable warning surface shall have a base diameter of 0.9 inch (23 mm) minimum and 1.4 inches (36 mm) maximum, a top diameter of 50 percent of the base diameter minimum...