list of deficiencies that the DOJ noted as needing correction: Where exit signs are provided, there are no exit signs with Braille and raised letters mounted on the wall on the latch side...
Search Results "Flared Side"
Commonly Searched Documents
-
ETA Opinion: ADA Signage at Exit Doors
-
1134A.2 Number of complying bathrooms
A minimum 18-inch (457 mm) clear maneuvering space shall be provided on the swing side of the door at the strike edge of the door. 9. ...
-
1134A.2 Number of complying bathrooms
A minimum 18-inch (457 mm) clear maneuvering space shall be provided on the swing side of the door at the strike edge of the door. 9....
-
Feature 6 - Restrooms
An accessible stall has a door wide enough to enter; floor space for a wheelchair user to roll up to the toilet; grab bars on the back and side wall nearest the toilet to support the person...
-
Section 1193.37 Information pass-through [1193.27 in the NPRM] (Section-by-Section Analysis)
In addition, manufacturers objected to the one-sided nature of the requirement and wanted manufacturers of peripheral devices and specialized customer premises equipment to be held accountable...
-
Designated Aisle Seats
a) of the 1991 Standards requires one percent (1%) of fixed seats in assembly areas to be designated aisle seats with either no armrests or folding or retractable armrests on the aisle side...
-
11B-404.2.7 Door and gate hardware
Where sliding doors are in the fully open position, operating hardware shall be exposed and usable from both sides. [Safe Harbor only applies to existing primary entrances.]...
-
Exercise Equipment and Machines
If the clear space is enclosed on three sides (e.g., by walls or the equipment itself), the clear space must be at least 36 by 48 inches....
-
5.9.1 Standing Supports Recommendation In Reference To Mammography Equipment
Rationale for recommendation The original criteria proposed in the NPRM included vertical standing supports on both sides of the equipment that were 18 inches in length....
-
Passing Spaces [1016.4]
T-shaped space extend a minimum of 48 inches beyond the intersection (figure 12) Either of these configurations provides enough space for people using mobility devices to move to the side...
-
Standing Supports [M305.2]
Rationale The original criteria proposed in the NPRM included vertical standing supports on both sides of the equipment that were 18 inches in length....
-
Requirement 6. Reinforced walls for grab bars.
Where the toilet is not placed adjacent to a side wall, the bathroom would comply if provision was made for installation of floor mounted, foldaway or similar alternative grab bars....
-
Alternative Designs. Bathroom as Shower Room
This turned out not to be the case, and a retrofit with an after-market in-line valve installed on the upstream side of the coupling turned out to be impractical due to the danger of backflow...
-
DETR
A low profile stand was constructed with a weight pad underneath and two cameras mounted above and to the side. Participants were recruited as they walked by the apparatus....
-
Wheeled Mobility Anthropometry Project
Anthropometry Project are discussed in connection with the following technical criteria: • Height of transfer surfaces on diagnostic equipment used by patients in a supine, prone, or side-lying...
-
Circulation Paths
Error/Omission: Objects protrude into circulation paths from the side or from posts. Objects that overhang circulation paths do not provide clear headroom....
-
Section 37.93 One Car Per Train Rule
wayside lifts is not required, in most circumstances, to “double-stop” in order to give passengers a chance to board the second or subsequent car in a train at the mini-high platform or way-side...
- Pilot Rock TQ700 Square Frame Square Utility Table
- Allegion Falcon SC60 Series Surface Mounted Door Closer
- Delta H2Optics Exposed Flush Valve 81T201BTA
- Pilot Rock T700 Square Frame Rectangular Utility Table
- Interface Whole Earth Collection WE151 Carpet Tiles
- Halsey Taylor Bi-Level HAC Green Cooler with Hydroboost® Bottle Filler
-
Vertical Dispersion: ADA Standard Section 221.2.3.2
Section 221.2.3.2 covers scoping requirements in the current ADA Standards for vertical dispersion in assembly areas.