The technical criteria for transfer supports are discussed under M301 Diagnostic Equipment Used by Patients in Supine, Prone, or Side-Lying Position and M302 Diagnostic Equipment Used by...
Search Results "Side Light"
-
M305 Supports
-
11B-804.2.1 Pass through kitchen
In pass through kitchens where counters, appliances or cabinets are on two opposing sides, or where counters, appliances or cabinets are opposite a parallel wall, clearance between all opposing...
-
11B-602.3 Operable parts
The flow of water shall be activated by a manually operated system that is front mounted or side mounted and located within 6 inches (152 mm) of the front edge of the fountain or an automatic...
-
1132A.1 Primary entry doors and required exit doors
The requirements of Sections 1126A.3 shall apply to maneuvering clearances at the side of the door exposed to common or public use spaces (e.g., entry or exit doors which open from the covered...
-
1132A.1 Primary entry doors and required exit doors
The requirements of Sections 1126A.3 shall apply to maneuvering clearances at the side of the door exposed to common or public use spaces (e.g., entry or exit doors which open from the covered...
-
11B-804.2.1 Pass through kitchen
In pass through kitchens where counters, appliances or cabinets are on two opposing sides, or where counters, appliances or cabinets are opposite a parallel wall, clearance between all opposing...
-
804.2.1 Pass Through Kitchen
In pass through kitchens where counters, appliances or cabinets are on two opposing sides, or where counters, appliances or cabinets are opposite a parallel wall, clearance between all opposing...
-
404.2.5 Thresholds
EXCEPTION: Existing or altered thresholds 3/4 inch (19 mm) high maximum that have a beveled edge on each side with a slope not steeper than 1:2 shall not be required to comply with 404.2.5...
-
608.2.2 Standard Roll-In Type Shower Compartments
Standard roll-in type shower compartments shall be 30 inches (760 mm) wide minimum by 60 inches (1525 mm) deep minimum clear inside dimensions measured at center points of opposing sides...
-
610.3.1 Rectangular Seats
The side edge of the seat shall be 1½ inches (38 mm) maximum from the adjacent wall. Figure 610.3.1 Rectangular Shower Seat...
-
1. Question: What is the minimum width needed for a non-level boarding railroad passenger station platform to meet the accessibility requirements of the Americans with Disabilities Act (ADA)?
varies from one builder to another, but it is not uncommon for the passenger car edge of the lift platform in the fully deployed position to be a number of inches away from the actual side...
- Landscape Forms Inc. Chase Park Trash Receptacle
-
4.1.3(17)(a)
Unless otherwise specified, accessible telephones may be either forward or side reach telephones. 2 A bank consists of two or more adjacent public telephones, often installed as a unit...
-
Accessible Round Table Style
Side aisles require at least six feet between the table and the side wall or other obstructions....
-
Segway Human Transporter
Its footprint is not much larger than the human body's and has a handlebar and platform similar to a scooter, but with two wheels side by side....
- WorkZone Safety Products Retractable Cone Bar
-
Examples of alternative ways to serve a customer when barrier removal is not feasible are:
Examples of alternative ways to serve a customer when barrier removal is not feasible are: At a dry cleaner's, providing curb-side service for a customer dropping off or picking up...
-
Alternate Roll-in Showers
The revised language clarifies the location of the entry at the end of the long side of the compartment (608.2.3)....
-
10. Can a transfer platform be an irregular shape as long as it incorporates the minimum rectangle of 14 by 24 inches?
The 24 inch side of the transfer platform must be free from obstructions to allow a person to transfer....
-
Clear Floor Space
Designers may decide which location is best suited for transfer on a particular ride.Because people transfer in different ways, providing additional space both in front of and to the side...
-
T704.3.2 Automated Route Identification Announcements
Signs displaying route identification information shall be provided on the front and boarding sides of non-rail vehicles. Signs shall comply with T702....
-
407.8 Reach Height and Depth
of operable part of stationary ICT shall be at a height conforming to 407.8.2 or 407.8.3 according to its position established by the vertical reference plane specified in 407.8.1 for a side...
-
4.10.12(3)
All floor buttons shall be no higher than 54 in (1370 mm) above the finish floor for side approach and 48 in (1220 mm) for front approach....
-
Reach Ranges and Operable Parts
REACH RANGES AND OPERABLE PARTS Forward and side reach 11B-308.2/3 Over projections 11B-308.2.2/3.2...