Door Protection Plate 194S 0.050" gauge with 4-sided bevel Materials: - Aluminum, Brass, Bronze, Stainless Steel...
Search Results "Side Light"
Commonly Searched Documents
- Hager Companies Door Protection Plate 194S
- Hager Companies Door Protection Plate 193S
-
Check-Out Aisles and Sales and Service Counters
Where the counter is a split-height counter, this requirement applies only to the customer side of the counter top....
-
1. Public Right-of-Way
Street ("Fillmore") and Steiner Street ("Steiner"); (2) Steiner between Grove Street ("Grove") and Fulton; and (3) the east side of 19th Street one block north of Wawona Street....
- Magnuson Group SOTARE Waste Receptacles
- PlayLSI Braille and Clock Panel Play Component
- Magnuson Group UMEA Waste Receptacles
-
1023.9 Stairway identification signs
sign, raised characters and braille floor identification signs that comply with Chapter 11B shall be located at the landing of each floor level, placed adjacent to the door on the latch side...
-
11B-407.4.1 Car dimensions
TABLE 11B-407.4.1 ELEVATOR CAR DIMENSIONS MINIMUM DIMENSIONS DOOR LOCATION Door clear width Inside car, side...
-
Wayfinding is more than just graphics (slides 2 – 4)
The lighting....
-
803 Dressing, Fitting, and Locker Rooms
Many comments opposed this exception since, as written, it would allow a 6 inch portion of the 5 foot turning space on both sides to be located beyond two side partitions, possibly resulting...
-
604.8.1.1 Size
Wheelchair accessible compartments shall be 60 inches (1525 mm) wide minimum measured perpendicular to the side wall, and 56 inches (1420 mm) deep minimum for wall hung water closets and...
-
604.8.1.1 Size
Wheelchair accessible compartments shall be 60 inches (1525 mm) wide minimum measured perpendicular to the side wall, and 56 inches (1420 mm) deep minimum for wall hung water closets and...
-
Technical Memorandum TM 2012-01 Electric Vehicle Charging Stations
The vehicle space(s) with the accessible charging station shall be at least 96 inches wide and shall provide a 36 inch wide (minimum) accessible route complying with TAS 402 on both sides...
-
5.9.2.1 Standing Supports on Single Ramped Entry Raised Platforms with Wheelchair Spaces Recommendations
5.9.2.1 Standing Supports on Single Ramped Entry Raised Platforms with Wheelchair Spaces Recommendations The Committee recommends standing supports located on both sides of platforms,...
-
604.8.1.1 Size
Wheelchair accessible compartments shall be 60 inches (1525 mm) wide minimum measured perpendicular to the side wall, and 56 inches (1420 mm) deep minimum for wall hung water closets and...
-
11B-604.8.1.1 Size
Wheelchair accessible compartments shall be 60 inches (1524 mm) wide minimum measured perpendicular to the side wall, and 56 inches (1422 mm) deep minimum for wall hung water closets and...
-
Part 1. Typical Issues for Voters Who Use Wheelchairs, Scooters or Other Mobility Aids
Ramps with a vertical rise of more than 6 inches must have handrails on both sides....
-
Sinks [4.24]
At those used briefly or intermittently, a side approach may be sufficient. A removable base cabinet can be used to make a sink adaptable for a forward approach....
-
3. FIXTURES and HARDWARE
Shelves: “If the clear floor space allows a parallel approach by a person in a wheelchair and the distance between the wheelchair and the shelf exceeds 10 inches, the maximum high side...
-
4.9.4 HANDRAILS
Stairways shall have handrails at both sides of all stairs....
-
RECOMMENDATIONS
., sidewall) and the side of the toilet seat. Permit rear or floor mounted swing-away grab bars on both sides of the toilet....
-
Features of Accessible Parking Spaces
Access aisles may be located on either side of the parking space except for angled van parking spaces which must have access aisles located on the passenger side of the parking spaces....
-
11B-406.5.3 Landings
The landing clear width shall be at least as wide as the curb ramp, excluding any flared sides, or the blended transition leading to the landing....