Search Results "Fixed Assembly Seating"
Commonly Searched Documents
- Kohler C3® 125 Elongated Bidet Toilet Seat With Side Controls and Tank Heater
- Pressalit Care Lift for Manually Height Adjustable Worktop
-
§ 37.121(a)
(a) Except as provided in paragraph (c) of this section, each public entity operating a fixed route system shall provide paratransit or other special service to individuals with disabilities...
-
§ 37.131(a)(1)(i)
(i) The entity shall provide complementary paratransit service to origins and destinations within corridors with a width of three-fourths of a mile on each side of each fixed route....
-
General: ADA Standard Section 803.1
Section 903.5 requires dressing room bench seats to be installed so that they are at the same height as a typical wheelchair seat, 17 inches (430 mm) to 19 inches (485 mm)....
-
Expert opinion on the current knowledge
Transfer boards are a common aid used to facilitate transfers for those who have limited arm strength and/or situations where the height differential between the initial and target seats...
-
Required Means of Egress [IBC §1007.1 (2003), §1003.2.13 (2000)]
The IBC (2003) permits one accessible means of egress from: wheelchair seating in assembly areas with sloped floors where the common path of travel meets aisle requirements for...
-
Head Room [4.4.2]
Otherwise, fixed barriers detectable by canes must define areas with less clearance. Gates, rails, curbs, and other fixed elements, such as planters, can serve as barriers....
- Pilot Rock Square Frame Square Table - Series TQ703
-
11B-803.1 General
Section 11B-903.5 requires dressing room bench seats to be installed so that they are at the same height as a typical wheelchair seat, 17 inches (430 mm) to 19 inches (485 mm)....
-
13. I do not need to fix it because I will help a disabled person get around barriers in my facility.
While it is good business practice to provide assistance to all your customers, and you are required to provide reasonable accommodations to people with disabilities, assisting...
-
711.4.5 Dissimilar materials
Noncombustible penetrating items shall not connect to combustible materials beyond the point of firestopping unless it can be demonstrated that the fire-resistance integrity of the horizontal assembly...
-
10. I have already been sued, so I am clear.
If you have been sued or paid a settlement and did not fix the issue, then you are still at risk....
-
a. Transfer Surface Adjustability
surface height range of 17 inches minimum to 19 inches maximum be applied to both diagnostic equipment used in the supine, prone, or side-lying position and diagnostic equipment used in the seated...
-
§ 37.129(b)
paratransit service for ADA paratransit eligible persons described in §37.123(e)(2) of this part may also be provided by on-call bus service or paratransit feeder service to an accessible fixed...
-
Recessed Doors and Gates: ADA Standard Section 404.2.4.3
Section 404.2.4.3 covers the current ADA Standards for maneuvering clearances at recessed doors and gates.
-
11B-411.2.3.2 Car designation signs
Applied plates are acceptable if they are permanently fixed to the jamb....
- Whitehall Mfg. Single Temp Hemispherical Pushbutton Pneumatic Valve, Conical Faucet, 8” Centerset
- Whitehall Mfg. Hot & Cold Hemispherical Pushbuttons Pneumatic Valve Conical Faucet 8" Centerset
- Whitehall Mfg. Hot & Cold Hemispherical Pushbuttons Pneumatic Valve Conical Faucet 4" Centerset
- Whitehall Mfg. 3374-8IN Hot & Cold Hemispherical Pushbuttons Pneumatic Valve Conical Faucet 8" Centerset
- Whitehall Mfg. Single Temp Hemispherical Pushbutton Pneumatic Valve Conical Faucet 4” Centerset
-
1132A.3, Item 4
A nominal 32-inch (813 mm) clear opening provided by a standard 6-foot wide (1829 mm) sliding patio door assembly is acceptable....
-
1132A.3, Item 4
A nominal 32-inch (813 mm) clear opening provided by a standard 6-foot wide (1829 mm) sliding patio door assembly is acceptable....