Where the width of the examination surface is less than 36 inches (915 mm), the clearance depth shall extend the full width of the equipment....
Search Results "Clear Width"
-
M302.4.1 Clearance in Base
-
M301.4.1 Clearance in Base
Where the width of examination surfaces is less than 36 inches (915 mm), the clearance depth shall extend the full width of the equipment....
-
M302.4.1 Clearance in Base
Where the width of the examination surface is less than 36 inches (915 mm), the clearance depth shall extend the full width of the equipment....
-
M301.4.1 Clearance in Base
Where the width of the examination surface is less than 36 inches (915 mm), the clearance depth shall extend the full width of the equipment....
-
Clarification on Standard Roll-In Shower Compliance
Standard roll-in type shower compartments shall be 30 inches (762 mm) wide minimum by 60 inches (1524 mm) deep minimum clear inside dimensions measured at center points of opposing sides...
-
406 Curb Ramps
These include specifications for running slope, surface, clear width, and wet conditions. Consistent with the scope of the guidelines, these requirements apply to facilities on sites....
-
Scoping [4.1.2(1), 4.1.3(1)] and Location [4.3.2]
Clear width, surface texture, running and cross slope, and the treatment of changes in level help determine the usability of walking surfaces by people with mobility impairments....
-
Comparison of Single-User Toilet Room Layouts: 2A, 2B, and 2C
Depending on the width of the hallway and other circulation issues, it can be preferable to swing the entry door into the toilet room....
-
11B-405.7.4 Change in direction
Ramps that change direction between runs at landings shall have a clear landing 60 inches (1525 mm) minimum by 72 inches (1829 mm) minimum in the direction of downward travel from the upper...
-
11B-405.7.4 Change in direction
Ramps that change direction between runs at landings shall have a clear landing 60 inches (1525 mm) minimum by 72 inches (1829 mm) minimum in the direction of downward travel from the upper...
-
Transfer Surface Size – M302.2.2 Seated Position
The Subcommittee discussed the width and agreed on a 21 inch minimum width based on anthropometric data and industry human factors experience....
-
4.1 Wheeled Mobility Device Dimensions
Data on occupied device sizes is most valuable for establishing clear floor area requirements....
-
11B-705.1.2.2.2 Parallel curb ramps
Detectable warnings shall extend the full width of the turning space at the demarcation between the street and the sidewalk less 2 inches (sic) (51 mm) maximum on each side....
-
11B-505.3 Continuity
Exception: In assembly areas, ramp handrails adjacent to seating or within the aisle width shall not be required to be continuous in aisles serving seating....
-
11B-812.1 General
Exception: Where vehicle spaces or access aisles are not adjacent to another vehicle space, access aisle, or parking space, measurements shall be permitted to include the full width of the...
-
11B-812.1 General
Exception: Where vehicle spaces or access aisles are not adjacent to another vehicle space, access aisle, or parking space, measurements shall be permitted to include the full width of the...
-
11B-705.1.2.2.2 Parallel curb ramps
Detectable warnings shall extend the full width of the turning space at the demarcation between the street and the sidewalk less 2 inches (sic) (51 mm) maximum on each side....
-
11B-505.3 Continuity
Exception: In assembly areas, ramp handrails adjacent to seating or within the aisle width shall not be required to be continuous in aisles serving seating....
-
T-Shaped Space: ADA Standard Section 304.3.2
Section 304.3.2 covers the current ADA Standards for t-shaped turning space.
-
2.2.2 Structural Anthropometry (i.e. Body and WhMD Dimensions)
Lateral most point, left (arm, leg, WhMD or accessory) Used to measure Occupied Width....
-
Length: ADA Standard Section 405.7.3
Section 405.7.3 covers the current ADA Standards for the required length of ramp landings.
-
11B-405.7.3 Length
The landing clear length shall be 60 inches (1524 mm) long minimum....
-
11B-405.7.3 Length
The landing clear length shall be 60 inches (1524 mm) long minimum....
-
11B-1009.2.6 Footrests and armrests
The armrest positioned opposite the water shall be removable or shall fold clear of the seat when the seat is in the raised (load) position....