Horizontal dispersion shall not be required in assembly areas with 300 or fewer seats if the companion seats required by F221.3 and wheelchair spaces are located within the 2nd or 3rd quartile...
Search Results "Play Area Ramp"
Commonly Searched Documents
-
F221.2.3.1 Horizontal Dispersion
-
§27.75(a) New facilities.
(a) New facilities—
-
221.1 General
Assembly areas shall provide wheelchair spaces, companion seats, and designated aisle seats complying with 221 and 802. In addition, lawn seating shall comply with 221.5....
- SafePath SAFELIFT™ Platform Weightlifting Surface
-
5.9.2.2 Standing Supports on Dual Ramped Entry Raised Platforms with Wheelchair Spaces Recommendations
integrated into the platform and stretching the full length of the platform (40-inch minimum) for dual ramped entry raised platforms....
-
D. What Does Title II of the ADA Require with Respect to Curb Ramps at Pedestrian Crossings?
Title II of the ADA requires state and local governments to make pedestrian crossings accessible to people with disabilities by providing curb ramps.2 This requirement applies if your state...
-
T302.3 Openings
Ramp and bridgeplate surfaces shall be permitted to have one opening 1½ inches (38 mm) maximum in width and 4½ inches (115 mm) maximum in length to allow the operator to grasp the ramp or...
-
Gaps
Gaps Where wheelchair spaces are provided on amusement rides, the floors of rides must be coordinated with the floors of the load and unload areas so that when the ride is at the...
-
1007.8 Two-way communication
Exceptions: Two-way communication systems are not required at the elevator landing where the two-way communication system is provided within areas of refuge in accordance with Section...
-
F202.6.5.5 Assembly Areas
Assistive listening systems shall comply with F219 and assembly seating shall comply with F221.
-
5.3 TABLEWARE AREAS
Install tableware, dishware, condiment, food and beverage display shelves, and dispensing devices in compliance with 4.2 (see Fig. 54).
-
11B-206.2.15 Golf facilities
In addition, accessible routes serving golf car rental areas; bag drop areas; course weather shelters complying with Section 11B-238.2.3; course toilet rooms; and practice putting greens...
-
4.3.11.1(6)
Smoke barriers shall have a fire-resistive rating of not less than one hour and shall completely enclose the area or room....
-
4.8.6 Cross Slope and Surfaces
The cross slope of ramp surfaces shall be no greater than 1:50. Ramp surfaces shall comply with 4.5....
-
4.8.6 CROSS SLOPE AND SURFACES
The cross slope of ramp surfaces shall be no greater than 1:50. Ramp surfaces shall comply with 4.5....
-
§ 38.125(c)(6)(i) Requirement
When in use for boarding or alighting, the ramp or bridge plate shall be attached to the vehicle, or otherwise prevented from moving such that it is not subject to displacement when loading...
-
§ 36.406(f) Assembly areas
(f) Assembly areas. ...
-
§ 36.406(f) Assembly areas
(f) Assembly areas....
-
F206.2.2 Within a Site
An accessible route is required to connect to the boundary of each area of sport activity....
-
206.2.2 Within a Site
An accessible route is required to connect to the boundary of each area of sport activity....
-
§ 38.29(e)
(e) For vehicles in excess of 22 feet in length with front-door lifts or ramps, vertical stanchions immediately behind the driver shall either terminate at the lower edge of the aisle-facing...
-
If a passenger loading area serves cars and vans, as well as buses, must the provisions for passenger loading zones and bus loading zones both be satisfied?
No, provisions for bus loading zones (§810.2) apply only to on-street bus stops and those bus loading zones that exclusively serve designated or specified public transportation...
-
Approach: ADA Standard Section 1002.4.6
One side of the wheelchair space shall adjoin an accessible route when in the load and unload position.
-
Partitions: ADA Standard Section 231.4.2
Section 231.4.2 covers scoping requirements in the current ADA Standards for partitions.