Features Constant Pressure Paddle Switch with Emergency Stop 4 Removable Caster Wheels Automatic Folding Ramp Platform Gate on Exit Side 36" x 54...
Search Results "Aisle Ramp"
Filters
Commonly Searched Documents
-
Harmar CPL400P Portable Vertical Platform Lift
-
4. Grievance Procedure
Curb ramp requests submitted through the City's grievance procedure trigger an investigation by DPW....
-
Suggestion by Eldon Tipping
Eldon Tipping As published in Concrete Construction magazine, September 1998, Eldon Tipping made suggestions for a specification for sloped random - traffic floors such as parking decks, ramps...
-
B8. Accessible Route
Does an accessible route connect the curb ramp to the accessible entrance? [ADA Stds 4.1.2(1)]...
-
11. Fixing my business will be too expensive; therefore, I am unable to do anything to reduce my risk.
striping, provided that its exists and there is sufficient contrast; 6) Faded, chipped, damaged, or deteriorated paint in otherwise fully compliant parking spaces and passenger access aisles...
-
11B-303.3 Beveled
Changes in level exceeding ½ inch (13 mm) must comply with 405 (Ramps) or 406 (Curb Ramps). FIGURE 11B-303.3 BEVELED CHANGE IN LEVEL...
-
T503.5 Exterior Illumination for Boarding and Alighting Areas
Where doorways have ramps, bridgeplates or lifts, the illumination shall be 1 foot-candle (11 lux) minimum for a distance of 3 feet (915 mm) measured beyond the edge of the ramp, bridgeplate...
-
303.3 Beveled
Changes in level exceeding ½ inch (13 mm) must comply with 405 (Ramps) or 406 (Curb Ramps). Figure 303.3 Beveled Change in Level...
-
Detectable Warnings
This warning was required since the sloped surfaces of curb ramps remove a tactile cue provided by curb faces....
-
Egress Signage
Toilet Rooms and Bathing Rooms (from 213.2.2 and 213.2, Exception 4) 216.9 TTYs (from 217.4.9) 216.10 Assistive Listening Systems (from 219.4) 216.11 Check-Out Aisles...
-
1129B.3, Item 2
One in every eight accessible spaces, but not less than one, shall be served by a loading and unloading access aisle 96 inches (2438 mm) wide minimum placed on the side opposite the driver's...
-
Scoping [4.1.2(5)]
Standard spaces must have an access aisle at least 5 feet wide, while those that provide van access must have an access aisle at least 8 feet wide....
-
Do access aisle borders (in blue) have to be painted on all four sides to be considered compliant?
I would say yes as the language in the code is pretty specific using the term "perimeter". I would also say that both of the "end" lines would/could be within the required length.
-
11B-221.2.1.5 Stadium-style movie theaters
The required wheelchair spaces shall be located on risers or cross-aisles in the stadium section that satisfy at least one of the following criteria: 1. ...
-
Chapter 9: Built-In Elements
provisions for benches concerning clear floor or ground space (903.2), back support (903.4), and height (903.5) addition of a requirement for check writing surfaces at check-out aisles...
-
Some wheelchairs weigh more than 600 pounds when occupied, and the design load of the lifts on our vehicles is 800 pounds. Is a transportation operator required to carry these “overweight” wheelchairs?
transportation if carrying the wheelchair and its occupant would be inconsistent with legitimate safety requirements, as when, for example, the wheelchair is so large it would block an aisle...
-
9.5 LOCKER ROOMS
Unobstructed aisle space in front of lockers used by handicapped people shall be a minimum of 42 in (1065 mm) clear width....
-
11B-221.2.1.5 Stadium-style movie theaters
The required wheelchair spaces shall be located on risers or cross-aisles in the stadium section that satisfy at least one of the following criteria: 1. ...
-
f-ii
Is the change in level from the floor to the lift surface ramped or beveled? [ADA Standards §§ 4.11.2, 4.5.2] Yes No...
-
Chapter 4: Accessible Routes
Chapter 4 contains technical requirements for accessible routes (402) and the various components of such routes, including walking surfaces (403), doors, doorways and gates (404), ramps...
-
11B-405.9.2 Curb or barrier
To prevent wheel entrapment, the curb or barrier shall provide a continuous and uninterrupted barrier along the length of the ramp....
-
303.3 Beveled
Changes in level exceeding 1/2 inch (13 mm) must comply with 405 (Ramps) or 406 (Curb Ramps)....
-
Components (R302.2) (Section-by-Section Analysis)
Curb ramps and blended transitions must comply with the technical requirements in R302.7 and R304. Ramps must comply with the technical requirements in R407....
-
Scoping [4.1.3(4)]
Stairs do not have to comply where vertical access (ramp, elevator, or lift) is provided....