Commenters noted that in guest rooms with two beds, each bed was positioned close to a wall, reducing access on one side....
Search Results "Head End Wall"
Filters
Commonly Searched Documents
-
806 Transient Lodging Guest Rooms
-
Bradley 3-Station Express Lavatory System MG-3
tankless water heaters ADA and TAS Compliant Serves 1 - 3 users at a time Standard lavatory spacing on 30" centers Contemporary flowing design Continuous bowl, sprayhead and end...
-
Trimco LDH100 Series Lockdown Hardware
In the event of an emergency, the LDH100 does not require a key or hex-wrench to lockdown the doors from the inside; simply push the button on the end cap and the exit device automatically...
-
Bradley 2-Station Express Lavatory System MG-2
tankless water heaters ADA and TAS Compliant Serves 1 - 2 users at a time Standard lavatory spacing on 30" centers Contemporary flowing design Continuous bowl, sprayhead and end...
-
Pilot Rock AT Series Traditional A-Frame Picnic Table With Steel Braces - Using Lumber
Cross supports are formed using galvanized steel channel to build rigid end frames and a sturdy seat support. ...
-
Quantum Single Load Dryer Front Control by Speed Queen
End-of-Cycle Signal. High Efficiency Exhaust Blower with Superior Airflow of 220 cfm (104 liters/sec). 100% Serviceable from the Front....
-
T-Base Communications Alternate Format Company
To be the full-service accessible communications department to large enterprise and government entities helping them communicate securely with their blind, low vision and print disabled end-users...
-
4.4.3 Implications of Mammography Equipment Components
In order to get an image with sufficient detail, a woman’s breast must rest on top of the breast platform and her chest wall needs to be flush with the front edge of the breast platform....
-
Maintenance
routes, such as filling ruts, reshaping a trail bed, replacing or reshaping surfacing material, repairing washouts, installing riprap to retain cut and fill slopes, constructing retaining walls...
-
3.3 Equipment Barriers and Solutions
., it may be hung on the wall or be in small print) Type the instructions in large print (at least 18 point font) and attach them to the equipment with a cord or chain so that a user...
-
Non-Tactile Signage
Finish & Contrast · light/dark contrast · non-glare finish · light/dark contrast · non-glare finish Location · 60" height to centerline on wall...
-
Identification [§216.5, §502.6]
Signs can be on posts, or where feasible, on walls or suspended from ceilings (an 80” minimum headroom clearance is required at signs suspended above circulation paths (§307.4))....
-
Bobrick Hat and Coat Hook B-6827
Hook 1" W, 6 1⁄2" H (25 x 165mm); projects 31⁄16" (80mm) from wall. Concealed wall plate....
-
104 Conventions
104.1.1 of the 2010 Standards provides that all dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific minimum and maximum end...
-
382.151 What are the requirements for providing Complaints Resolution Officials?
Foreign carriers must make a CRO available at each airport serving flights the carrier operates that begin or end at a U.S. airport....
-
M305.3.1 Length (Section-by-Section Analysis)
Second, for diagnostic equipment with wheelchair spaces that permit pass-through from one end to the other, the length of the gripping surface for the horizontal standing support must be...
-
5.7.1.2 Lift Compatibility Clearance in Base for Imaging Equipment (M301)
cases, a ceiling-mounted lift may be a better method for some types of imaging equipment because the portable lift would need to access the diagnostic imaging table from the side or far end...
-
18. Does an employer have to hold open an employee's job as a reasonable accommodation?
The employer must consider whether it has a vacant, equivalent position to which the employee can be reassigned for the remaining four months of leave, at the end of which time the employee...
-
Preface for Day 2: Discussion led by Earle Kennett
four issues, because, quite frankly, if you look at the agenda, we’ve got four panels, and based on what happened yesterday, I’m concluding that we’re not going to have much time at the end...
-
Highest and Lowest Heights Obtained
Percentiles Protocol 5th 25th 50th 75th 95th End...
-
IV. Public Comments and Commenters
The proposed guidelines provided a 90-day period for the submission of comments by the public, ending September 13, 1990. The Department received 562 timely comments....
-
1017.4 Passing Spaces
Where the full length of a trail does not fully comply with the technical requirements in 1017, a passing space is required to be located at the end of the trail segment that fully complies...
-
1.1.4 Walk cross slope
overall cross slope (the direction perpendicular to the running slope) by establishing elevations at the outside edges of the walking surface at 10 ft (3 m) intervals beginning at one end...
-
Whitehall Mfg. WH2105BAR Bariatric Toilet Siphon Jet Type Off-Floor
Product Details Material: Stainless Steel Brand: Dura-Ware Fixture Width: 14" Off-Floor/Wall Waste: Available as Option Top Supply: Available...
