The following accessible features are provided in the bathroom: • Comparable vanity counter top space (section 806); • Alternate roll-in type shower with folding seat is 36 inches...
Search Results "Serving Space"
Filters
Commonly Searched Documents
-
Plan 4B: 13-Foot Wide Accessible Guest Room
-
Plan 6B: 12-Foot Wide Accessible Guest Room
The following accessible features are provided in the bathroom: • Comparable vanity counter top space (section 806); • Transfer shower (section 603.2); • Shower seat (section 610.3...
-
Viewing Scopes [1011.2, 1011.3, and 1011.8]
At viewing scopes used from a seated position, a minimum of 36 by 48 inches of clear ground space positioned for a forward approach to the viewing scope must be provided....
-
Forward Reach [4.2.5]
Forward reaches are measured to the edge of available clear floor space. This accommodates high and low reaches and assumes some forward bending....
-
68.101(c)(5)(E) Signage at toilet rooms or bathrooms
Toilet rooms or bathrooms serving the leased area which are not accessible shall be provided with signage complying with TAS 703.1, 703.2.4, 703.2.5, 703.6.2 and 703.7, indicating the location...
-
Plan 6A: 12-Foot Wide Accessible Guest Room
The following accessible features are provided in the bathroom: • Comparable vanity counter top space (section 806); • Transfer shower (section 603.2); • Shower seat (section 610.3...
-
Purchase of multiple tickets. (Section-by-Section Analysis)
There are various ways that covered entities can accommodate groups that require at least one wheelchair space. ...
-
5.9.2.2 Standing Supports on Dual Ramped Entry Raised Platforms with Wheelchair Spaces Recommendations
5.9.2.2 Standing Supports on Dual Ramped Entry Raised Platforms with Wheelchair Spaces Recommendations The Committee recommends standing supports located on one side of the platform,...
-
Fixtures
Fixtures TAS 604.3.2 also allows the clear floor space and clearances required at other “fixtures” to overlap the water closet clearance....
-
4.29.2* Detectable Warnings on Walking Surfaces
Detectable warnings shall consist of raised truncated domes with a diameter of nominal 0.9 in (23 mm), a height of nominal 0.2 in (5 mm) and a center-to-center spacing of nominal 2.35 in...
-
M303.2.1 Orientation (Section-by-Section Analysis)
The MDE NPRM proposed to require wheelchair spaces to be designed so that a patient in a wheelchair using diagnostic equipment would be oriented in the same direction that other non-wheelchair...
-
10) Assembly areas
* Assistive listening systems: Assembly areas with audio-amplification systems must have a listening system that serves a reasonable number of people, but at least two....
-
11B-812.5.4 Arrangement
Vehicle spaces and access aisles shall be designed so that persons using them are not required to travel behind vehicle spaces or parking spaces other than the vehicle space in which their...
-
11B-812.5.4 Arrangement
Vehicle spaces and access aisles shall be designed so that persons using them are not required to travel behind vehicle spaces or parking spaces other than the vehicle space in which their...
-
M303.3 Entry
Where there is a change in level at the entry to wheelchair spaces, the change in level shall comply with M303.3....
-
M303.3 Entry
Where there is a change in level at the entry to a wheelchair space, the change in level shall comply with M303.3....
-
Facilities Serving Beaches [F248.1.1]
access routes are required when an entity that administers or manages a beach constructs or alters any circulation paths, parking facilities, toilet facilities, or bathing facilities that serve...
-
What is best way to provide accessible curb-side EVCS (like parallel parking)?
You may wish to refer to the new CBC Chapter 11B provisions as “guidelines” because they were crafted to address vehicle spaces that are parallel to the vehicular way as well as the more...
-
M302.1 General (Section-by-Section Analysis)
public comment and evidence presented to the MDE Advisory Committee, in the final rule the Access Board has added an exception to this requirement for weight scales that contain wheelchair spaces...
-
Knee and Toe Clearance (M303.2.4)
M303.2.4 would require the depth of wheelchair spaces to include knee and toe clearance of 17 inches minimum and 25 inches maximum....
-
M303.2.2 Width (Section-by-Section Analysis)
Thus, the final rule retains the 36-inch wheelchair space width requirement....
-
1002.4.2 Slope
The floor or ground surface of wheelchair spaces shall have a slope not steeper than 1:48 when in the load and unload position....
-
1002.4.2 Slope
The floor or ground surface of wheelchair spaces shall have a slope not steeper than 1:48 when in the load and unload position....