All dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific minimum and maximum end points....
Search Results "Maximum Reach Depth"
-
2010 ADA Standards
-
Accessible Slopes
For the cross slope of an accessible route the maximum slope allowed is 1:48....
-
Toilet Compartment Access
Where located in the front partition, the door opening shall be 4 inches (100 mm) maximum from the side wall or partition farthest from the water closet....
-
Re: Service Counters
For code compliance, one must create a reasonable standard for sufficient depth for accessible use. Reasonable persons will disagree on that number. Why bother? ...
-
AJW Architectural Products U526 Series U526-10 Sanitary Napkin/Tampon Dispenser - 10 cent Operation - Recessed
Flange will adjust from a 1" minimum to a 6" maximum wall depth....
-
Panda S.90 All Aluminum Slim Profile Multi-Slide Door System
Maximum Panel Height: Up to 10 feet. Maximum Panel Width: Up to 4’6″ feet. Panel Weight: Approximately 6 to 7 lbs/sqft depending on overall panel size....
-
11B-705.2 Detectable directional texture
The depth of the texture shall not be less than 36 inches (914 mm). FIGURE 11B-705.2 ‡‡ DETECTABLE DIRECTIONAL TEXTURE...
-
M303.2.2 Width (Section-by-Section Analysis)
(Significant Changes – Width and Depth of Wheelchair Spaces), and discussed briefly below....
-
Section 5 References
“Revised Knee Clearance Depth and Footrest Clearance dimensions for sizing of mammography equipment.” Memorandum. April 23, 2013....
-
Teeing Grounds
A rectangular area usually two club-lengths in depth, the teeing ground’s borders are defined by the outside limits of two “tee-markers.”...
-
5.3.2 Transfer Sides Recommendations for M301
The transfer surface shall be located to provide options to transfer from a mobility device onto one short side (depth) and one long side (width) of the surface....
-
15. Can I store my lift and bring it out only when it is requested by a person with a disability?
In addition, the ADA Standards specify that a lift must be located at the proper water depth and with the necessary space around it to maneuver a wheelchair....
-
11B-705.2 Detectable directional texture
The depth of the texture shall not be less than 36 inches (914 mm)....
-
205 Operable Parts
securement devices (Exception 7) exercise machines (Exception 8) The proposed rule contained an exception from the technical requirement that operable parts be within accessible reach...
-
804.6.6 Refrigerator/Freezer
Combination refrigerators and freezers shall have at least 50 percent of the freezer space 54 inches (1370 mm) maximum above the finish floor or ground....
-
11B-404.2.5 Thresholds
Thresholds, if provided at doorways, shall be ½ inch (12.7 mm) high maximum. Raised thresholds and changes in level at doorways shall comply with Sections 11B-302 and 11B-303....
-
1) Where the Standard specifically refers to 303
1) Where the Standard specifically refers to 303, such as 403.4 changes in level for walking surfaces: Here it is clear that changes in level that comply with either the ¼" maximum vertical...
-
Thresholds [§404.2.5]
The edge must be beveled 1:2 maximum above a height of 1/4”....
-
11B-703.5.4 Character proportions
Characters shall be selected from fonts where the width of the uppercase letter “O” is 60 percent minimum and 110 percent maximum of the height of the uppercase letter “I”....
-
11B-703.2.4 Character proportions
Characters shall be selected from fonts where the width of the uppercase letter “O” is 60 percent minimum and 110 percent maximum of the height of the uppercase letter “I”....
-
11B-404.2.5 Thresholds
Thresholds, if provided at doorways, shall be ½ inch (12.7 mm) high maximum. Raised thresholds and changes in level at doorways shall comply with Sections 11B-302 and 11B-303....
-
11B-903.3 Size
Benches shall have seats that are 48 inches (1219 mm) long minimum and 20 inches (508 mm) deep minimum and 24 inches (610 mm) deep maximum. [2010 ADA Standards] 903.3 Size....
