This warning was required since the sloped surfaces of curb ramps remove a tactile cue provided by curb faces....
Search Results "Exterior Ramp"
-
Detectable Warnings
-
216 and 703 Signs
in assembly areas; occupant names, building addresses; company names and logos; signs in parking facilities (except those identifying accessible parking spaces and means of egress); and exterior...
-
11B-217.4 TTYs
However, the requirement for at least one TTY on an exterior site cannot be met by installing a TTY in a bank inside a building....
-
Measuring Surface Firmness and Stability
Additional information about these projects is available at www.access-board.gov/research /completed-research/accessible-exterior-surfaces....
-
Tactile Signage
Requirements for tactile signage apply to exterior sites but are not intended for building names (except at rail stations) or addresses....
-
220.1 General
If a bank provides both interior and exterior ATMs, each such installation is considered a separate location....
- TechnoGym® - Radiant Inclusive Commercial Fitness System
-
Chapter 4: Accessible Routes
Chapter 4 contains technical requirements for accessible routes (402) and the various components of such routes, including walking surfaces (403), doors, doorways and gates (404), ramps...
-
11B-405.9.2 Curb or barrier
To prevent wheel entrapment, the curb or barrier shall provide a continuous and uninterrupted barrier along the length of the ramp....
-
Components (R302.2) (Section-by-Section Analysis)
Curb ramps and blended transitions must comply with the technical requirements in R302.7 and R304. Ramps must comply with the technical requirements in R407....
-
Scoping [4.1.3(4)]
Stairs do not have to comply where vertical access (ramp, elevator, or lift) is provided....
-
11B-705.1.1.3 Color and contrast
Replacement of less than 20 percent of existing detectable warnings at a single contiguous location shall be permitted to be in-kind at existing curb ramps, islands, or cut-through medians...
-
303.3 Beveled
Changes in level exceeding 1/2 inch (13 mm) must comply with 405 (Ramps) or 406 (Curb Ramps)....
-
11B-404.2.4.1 Swinging doors and gates
Add 6 inches (152 mm) at exterior side of exterior doors....
-
Selecting a TTY
Vandal-resistant and weather proof TTYs are available for outdoor use, including at exterior-only sites such as highway rest areas and parks....
-
C1-f
If the slope of part of the accessible route is more than 1:20, does it meet the following requirements for an accessible ramp? Yes No...
-
Element
., telephone, curb ramp, door, drinking fountain, seating, or water closet....
-
ELEMENT
., telephone, curb ramp, door, drinking fountain, seating, water closet....
-
Section B: Passenger Drop-Off Area
(§503.5) B4 Is a curb ramp provided if a curb separates the access aisle from the accessible route to the accessible entrance?...
-
216 Signs
Interior and exterior signs identifying permanent rooms and spaces shall comply with 703.1, 703.2, and 703.5....
-
(4) the City's Guidelines for Paving and Accessibility Compliance
(4) the City's Guidelines for Paving and Accessibility Compliance which permits the City to install curb ramps up to two years after re-paving;...
-
E1-d
Where the slope of the accessible route is greater than 1:20, does this area meet the following requirements for an accessible ramp? Yes No...
-
68.10(10) Curb Line
(10) Curb Line--A line that represents the extension of the face of the curb and marks the transition between the sidewalk and the gutter or roadway at a curb ramp or flush landing....
-
11B-303.3 Beveled
Changes in level exceeding 1/2 inch (13 mm) must comply with Sections 11B-405 (Ramps) or 11B-406 (Curb Ramps). ◼ ...