The size of characters must be based upon the intended viewing distance....
Search Results "Clearance in Base"
-
A4.30.2 CHARACTER PROPORTION
-
§ 37.139(d)(4)
description of the planned comparable paratransit service as it relates to each of the service criteria described in §37.131 of this part—service area, absence of restrictions or priorities based...
-
§ 38.83(c)(1) Design load
plates 30 inches or longer shall support a load of 600 pounds, placed at the centroid of the ramp or bridge plate distributed over an area of 26 inches, with a safety factor of at least 3 based...
-
703.2.5 Character Height
Character height measured vertically from the baseline of the character shall be 5/8 inch (16 mm) minimum and 2 inches (51 mm) maximum based on the height of the uppercase letter "I"....
-
A4.2.1(1) Space Requirements for Wheelchairs
Thus, a minimum clear width of 32 in (815 mm) will provide adequate clearance....
-
A4.2.1(1) Space Requirements for Wheelchairs
Thus, a minimum clear width of 32 in (815 mm) will provide adequate clearance....
-
Construction and Manufacturing Tolerances
Grab Bar Diameter and Clearance...
-
F. Consultation with Food and Drug Administration
The FDA-CDRH may develop a guidance document to inform manufacturers how it intends to apply its regulatory authority to clearance or approval of medical devices addressed in the Access...
- Lang Equipment Co. Heavy Duty Throw Latch & Keeper for Bathroom Stall Door
- Forms + Surfaces Summit Bike Rack
-
Technical Memorandum TM 2014-24 Location (Accessible Routes)
Although the term "same area" is not defined in TAS, it shall mean "not in a different section of space within a building" based on TAS 106.3 and the definitions from collegiate dictionaries...
-
Technical Memorandum TM 2013-12 Number of Accessible Elements and Spaces
For example, health care providers are subject to compliance with TAS based on Chapter 469.003(a)(4) and Rule 68.20(c)(6) and since there are no exemptions or scoping limits for examination...
-
Height
The maximum height in ADAAG was used because there was no other objective information available upon which to base a decision on effective height for assisted transfers....
-
704.3 Volume Control Telephones
Amplifiers on pay phones are located in the base or the handset or are built into the telephone. Most are operated by pressing a button or key....
- Just Manufacturing Classroom Concealed Ledgemount Teardrop Handles Restricted Swing Faucet
- Just Manufacturing Concealed Classroom Faucet with High Rise Spout
- CRL Jackson 900 Series Floor Mounted Door Closers
-
§382.19(c)(1)
In determining whether an individual poses a direct threat, you must make an individualized assessment, based on reasonable judgment that relies on current medical knowledge or on the best...
-
STEP 2
STEP 2 Determining what is needed based on Table 240.2.1.2: Table 240.2.1.2 Number of elevated play components provided Minimum number of ground-level play components...
-
TTY
Equipment that enables interactive text based communications through the transmission of frequency-shift-keying audio tones across the public switched telephone network....
-
C201.1 Scope
Manufacturers shall also conform to the requirements in the Revised 255 Guidelines for support documentation and services, including electronic documents and Web-based product support....
-
TTY
Equipment that enables interactive text based communications through the transmission of frequency-shift-keying audio tones across the public switched telephone network....
-
Written Explanation for Refusal of Transportation
[Sec. 382.31(e)] In the situation where refusal of transportation is based on safety concerns, the written notice must include the carrier’s reasonable and specific basis for its opinion...
-
12183(b) Elevator
mall, or the professional office of a health care provider or unless the Attorney General determines that a particular category of such facilities requires the installation of elevators based...